Hi all, I have a new problem popped up last week. Starboard side gear was stuck in neutral. Could not shift forward or reverse. After playing with it a bit, it started working fine. This week I tried while engine was off and could not shift. Port side is fine it clicks up, center and down without a problem. Starboard won't. At this point I am not sure it is the cable gone bad or where it is hooked up to on the engine side. Any ideas or input from anyone, next step I should do. I do not know much about mechanics of engine, so if you suggest something would appreciate it if you could be clear where on the engine I would check. Most likely I will have mechanic over, but if I can figure out hopefully I can save some money Until last week there were no problems. Last week it was a brief problem. this week I did not want to force it too much and end up with a bigger problem. This is on a carver 356 aft by the way with gas mercur engines.