does anyone know where I can find this? I have been searching, high and low with no luck. I’m doing a partial gut demolition on my boat in the Contractor accidentally tossed it.

Hello all!



I recently purchased a 1983 Carver 3207. So far my wife and I really like it. It is located on Lake Winnebago in Wisconsin.



Looking forward to learning as much as possible about it.



A HUGE thanks to Phrancus for posting the manuals for so many model boats. It really is a significant help.



On the documentation that he has gathered, I only found the single file (manual) for the 3207 model. Are there other manuals available for that model? Would manuals for other models provide similar infor ...

As the title says, I am in search of a 1979 Carver Santa Cruz 25' engine cover box. As an alternative I could use detailed pictures of one so that I can attempt to replicate it. In the attached picture you can see that I process the cushion for the engine cover but not the box. Thanks in advance.

Hi, I have a 1986 Carver 4207. We took a 55 NM trip two weeks ago to get a bottom job. Once at the dock, we noticed our galley bilge full of salt water. Clearly, our float switch isn't working, thankfully the hard-wired breaker switch on the electrical panel is working, and when in the on position it empties the bilge. We had the bilges checked at the haul-out marina and they found no compromises. When they put us back in the water the bilge filled again and we had to manually turn the bilge pum ...

On the base of our head (Crown Head I'm pretty sure), there is a reservoir that looks like it should contain toilet fluid of some sort. There was a nylon hose attached to the nipple but it wasn't connected to anything on the other end. Where is this supposed to attach to? What type of fluid should go in the reservoir?

Hi group, I need to remove my port side prop shaft strut. There is access to the starboard side inside aft closet. There appears to be a hatch beside the aft bed under the step ? Is there an easy way to get to the hatch without having to cut the carpet ?
Thanks in advance

Hello all,
I have a 1998 405 with a kohler 8e 8000 watt generator. Im trying to find a service manual, either online or printed. Also, the id tag states model number is 8E with a spec number 110307 and serial number 463426. is there a differant number I should be using to purchase parts, It seems that most model numbers are longer then 8E.
Thanks Tim

recently purchased 1998 carver Trojan 400 express. Ac compressor turns on blows cold air then trips breaker. No water coming from boat. Is there a valve I need to turn on ?

Hey Mates,



I would like to install a chain 'wash down' hose when weighing the anchor on my 2005 Mariner.

I am thinking of tapping into the line that feeds the sink on the bridge deck. I figure that I'll put in a 'T' fitting and then bring it to a valve under the forward 'rumble seat' featured on this model.

My questions for the crew:

a. Do you know what size inside diameter is utilized on our Carver water lines?

b. Any thoughts or ideas from anyone who has already tackled this project?



Thanks,
...

hi everyone ,i hope you doing well.
i have a carver marinero 350 2000 with 2 cummins diesel that doesnt have the original propellers, im looking to know the original propeller number . if someones knows ,please i will appreciate the information.