OK, so stupid question. I just purchased a propane grill (Kuuma). Instead of using the small screw on tanks, can I just purchase a propane grill set up with regulator from Home Depot and use that? I should know this but..

Looking for some help in replacing my existing garmin system with newer equipment. Have 1040sx and wanting to swap to (2) 1712's (have the equipment) . Located in Hampton. VA. anyone know anyone in the area?

Anyone
Please help me locate a sliding hatch lock for a 1989 Caver Allegra 2587. I have spent two years rebuilding this project and now I would like to finally locate the last item I need.
Thank you
Terry

Hi. After haul out fall 2020 port alum tank started to leak from an unseen site. Tank was full and appears to have pinhole leak about a cupful daily. Location is Mission Bay, San Diego. Plan local trips to San Diego Bay some nearby fishing. Mexico---No. May trip to Oceanside/Catalina. Boat is 1988 Aft Cabin 3807 with twin 454s. Thought we would replace 140 gal port tank with custom made alum smaller tanks made locally to avoid pulling engine and blackwater tank. Now I am advised this is no ...

Hello working on my 2004 Carver 36 and the engine compartment blowers are not getting power, I have power at the helm switch and cabin panel but no power to the blower motor themselves, I fed 12v with a power probe directly to the motor and the blower worked? So I checked the ground on the bus bar and it's good? So where could be the problem?

I have Cummins 6BTA s on my 1998 Carver 405.

Port engine ran hot coming from having it pulled for bottom painting. Found the impeller Shot with all the fins off. Out of my pay grade to finish it up right. Hired the local engine guy and he ended up needing to remove a motor mount to pull the water pump and after cooler and by doing this the shaft must be disconnected from the transmission just to be sure that it won’t get bent. I have read that Cummins should have thought this through before putt ...

I am interested in getting an autopilot system that will work with my Simrad Evo3 chart plotter for my 2000 396. I am finding it difficult to find detailed information related to installation. Is that because this is something you should not try and do yourself? I've pretty technically capable... That said I am not very knowledgeable on hydraulics, and I am having difficulty finding detailed information about how to install a net new autopilot, or even details about what brand/model steering s ...

So, I fired up both engines this weekend , tested the transmissions, and all seamed good. Tested the trim tabs on both sides and the did not seem to move down, the would move up slowly. Is there a procedure for testing these or is there anything I should be looking for. All this was down out of the water as the boat is still on blocks.

Jason

My new to me 2000 Carver 396 came with a Side Power 12v bow thruster which for most situations was adequate for docking, but the marina we are in has strong wind and currents, so I decided to add a stern thruster. This boat has extremely limited internal space at the transom so an most brands of thruster would not work. I opted for a dual 24v SideShift ST350 configuration to limit the needs for interior components.



Day 1, Out of the water!





The physical mou ...

Guys, I'm sure this has been discussed before. I went to the boat to glue down my Sea Deck, I connected my city water hose to the boat. No pressure out of taps. Pressure , a lot, from the end of the hose but when I connected it to the boat, nada. I searched because I'm sure this has happened. Please enlighten me.
Mucho thanks, Andrew