I have a 2000 356 i mounted rails on the swim deck and whe I drilled into the deck i found water and rotten wood between the 2 layers of fiberglass in one section. Appears that the deck in very soft near pull up handle for swim latter. I hear this is a common problem with this boat. Has anyone else experienced this problem and how did you repair it ?? I am thinking I am going to have to remove deck box and cut the top layer of fiberglass out and replace the rotted section and re glass it. Any ot ...

I am in the chicago area would like to replace the swim platform hand hold on my 1999 356. Where can i find an original part?

I need to replace the VDO rudder sensor on my 85 36' Carver Mariner. Does anyone have a location that I can purchase this from. This is an odd size as well.. Thanks for any help that you can give me. See the pic below.

I am trying to determine how I can replace my stair and other overhead accent lighting either using the original 12v incandescent lights or just 12v LED. I can't seem to locate lights that would fit inside the existing tubes. Also, I don't have access behind the stairs but there is a little slack in the wires so I would need to solder the new connections to whatever it would be on the outside.

Does anyone have any experience replacing these and if so with what? I have attached a couple of phot ...

All,
My salon Marine Air 16,000 is tripping the breaker as soon as it kicks in. My A/C Pump is running and both my Forward and Aft units are functioning fine. I read somewhere that it could be the startup capacitor but I am not sure where to start with that. Is there any advice out there for troubleshooting this sort of problem?
Thanks in advance.
Bryan

What years did Carver make the 460 Voyager?

Carver 33 SS 2006 with Crusader 6.0 MPI engines and ZF63 transmissions.



We had a touch and go. Afterwards, we were getting a vibration at about 2100 RPM’s in the starboard engine. A friend of mine pulled the starboard prop. I got the prop repaired. The boat ran fine after that. However, I only got it up to about 2700 rpm’s.



(I have removed one of the props before (can’t remember which) chasing down an RPM problem which turned out to be water in the fuel filter).



Later in the fall, we hit somethin ...

Who has taken their Caver to the Bahamas, Exumas, Turks and Cacos perhaps? What boat, when and how long.

We are in the early stages of planning for this coming winter on our 396.

Cheers

Zoomie J

Hello All!

I have the Volvo 480 hp diesels with ZF model 280-1A transmissions. While under power at 1900 RPM my starboard transmission went to neutral. Tried unsuccessfully to get it into forward, but would go into reverse no problem. I have checked the coils, solenoid valves and valve body with no luck. Verified electronic shifter operational. This is a new boat to me and certainly was not counting on a major repair.

Suggestions please! Qualified mechanics in my area that might be able to fix.
...

This looks like the year I will finally install electronic ignition in my Carver. I am going to use my stimulus check and stimulate my mechanics pocketbook. The kit he uses includes two new distributors and coils and wiring. I am also going to have him change out the sparkplugs at the same time.The current plugs along with the points have been installed since 2015 just before I bought the boat.

As long as nothing else breaks down that is the plan.