Has anyone ever seen a good 3D cutaway of an older Carver boat? Additionally, has anyone ever seen (or created) a photo of a boat with all (or the major) parts labeled and named? I have my original Carver operating manual (and pdf file), but I'm a visual and tactile learner - for me a picture WOULD be worth a thousand words. Thank you.

We have a good condition 1988 28' Voyager with twin Merc 230 engines. After the winter neither will start and both have 16000 hours on them. Should we repair or replace with rebuilt units costing $2K each? What do you all recommend? Is 16000 hours near the end of life of these engines? How about the transmissions and V-drives too? We want to keep the boat, make it reliable, not sell it. Help?

Jim

Hey guys,

Just had a sand bar come at me at 25kts and ground my boat. I didn't see it coming. yes ha ha

My props have been worked a lot and I may need new props.. Volvo d-12's

I had 4 blade ZF 29 X 32.2 with a slight cup..I got 2370 rpms and WOT speed was 27.3 kts/31.4 MPH

wondering what props you are using on your boat and what number are you getting.

hey Guys, I have a 2004 Voyager 570..

looking for prop advise

Ok so i'm not sure but i think i'm going to need to replace my hot water heater . My question is whats the difference between a electric hot water heater with side connections from lowes for 300 and the marine one for 800.00 they are both around the same size same electrical specs from what i can see . i don't have the connections for the engine. so i'm wondering why the one from lowes wont work just as well any ideas?

Had new to me 1985 Carver Mariner 36 out today for fourth time. Noticed loud knocking sound when in forward only on both drives. Each drive had same sound independently. Also when above idle the knocking disappears. Sounds like coming from in the salon area. No burnt smell or smoke or anything abnormal. After running for 10 minutes or so it somewhat stopped but occasionally would reoccur? Any thoughts would be appreciated. BTW it’s sunny and finally above 60 def in Indiana!

Hi All,
Very exited to splash our recently purchased 1986 Carver Voyager 2827. My wife and I have been recreational boating for many years. We both enjoy being on the waters of Eastern Lake Ontario. The hope is that with a larger vessel we will be able to spend more of our short summers on the water. Any and all comments or suggestion would be appreciated.

Hey there!

New to the Carver and boating world.

We just got our 1989 Montego 2557 in the water, and it runs very nice. I noticed the steering is a bit stiff. I feels the same engine running or not. I topped up the power steering fluid as it was a bit low. From what I have read, it could be a steering cable that is just old and worn out. I am wondering how I can narrow it down to the cable? If it is the cable, is there anything else I should replace while replacing the cable? Also, if anyone ...

Can someone provide the number for an oil filter for a 355 with 454s? It currently has OE and because they are remote I can't just specify the year and make at the parts store.

Finally the old carver MakinTime is floating, here are a few pics of it launched and a few of my winter projects.. custom cabin door and helm console working on doing something with the upper helm controls as well to freshen it up!

She might be a 85 but we love this boats layout and hope to enjoy her for some years to come.