Hello Folks
I am Dennis and I was wondering if anyone knows the color white used on the hull of the 1987 Carver 3257 Montego. I am refurbishing Her and need to paint the hull over. I believe someone told me once it was Carver simple white or something like that. any information would be greatly appreciated.. Just finished repairing and painting bottom. Thanks in advance for any help.
WELCOME ABOARD

Well, not really. I've been down to the boat a couple of time, did some maintenance, changed oil, cleaned the bilge, (after the oil change, so I see a reverso system in my future!) laid around, dreamed of warm breezy days.



But Today we were in full swing. I dewinterized, (which means for me, removing the snap on vent covers, turn off the heaters in the engine room, remove the heater from the head, and turn on the ice maker. ) Then the cleaning session came in full tilt.



...

Got the new Carpet installed today on our 1985 3607 aft cabin. Got the salon and aft cabin carpets installed by a friend who is a excellent carpet layer! Decided to do some cedar around the aft Bedroom to change things up a bit...still have to re upholster the bed sorround. Everything needs to go together yet but new carpet really freshens things up here are some pics.. -Tim

Who make the canvas tops for Carver? Mine is in need of help. Last boat i found out that I could buy a factory canvas cheaper than having it made after words.

Hi. I purchased a 2001 444 last fall and had props sent out for scanning. I am told they are of Canadian manufacture (24 x 30) and the blades are not welded equal distance around hubs. Rear cutless bearings wore out in less than 400 hours.
Anyone heard of this issue?

Lots of $'s to replace.

Thanks

Thanks for accepting me to the group. We are from New Zealand and have our Carved 1999 four fifty stationed in Gulf Harbour marina. Fuhrfrumwurken was from P.A USA and is still in excellent condition. It's wet and cold down under so we have ordered an enclosed Flybridge from a local marine supplier. Looking forward to adventures with her and our family and friends. Wish you all safe boating.

I have decided on a carver 53. I like the idea of having statrooms forward of the engines and generator. The wife likes the master in the aft cabin of carver 504. Does anyone have noise levels when engines and or generator is running.

I am a new menber and recently purchased a 355 Aft Cabin. I have only had the boat out3-5 times for short runs. I am a remoldeling the boat to bring it back to a beautiful condition, the bones are very good. My question is any ideas on why the oil PSI is 80-85 on both engines? I poke around at15-1800 RPM'S. Also, My water temps are 180 and 190 degrees. Any suggestions would help. I am a little embarrassed, I haven't checked the manual, but all seems high. Csdaman2

I own a 2007 42SS. Bought it two years ago. My refrigerator needs to be replaced. Problem is the outside dimensions of a new Nova Kool RFU9000 9.1 CU FT AC/DC Two Door Refrigerator & Freezer aren't the same as the existing unit. The new units are approximately 2 inches longer in depth and if installed would prevent the hatch access to storage area under galley from opening. Has anyone encountered a similar situation and did anyone come up with a suitable solution?



Appreciate any feedback ...

I know it's not me. This is a fun way to see who owns what year boat.

My Carver is a 1981 3007 Aft Cabin