I can't see placards on my engines and couldn't get an answer from my books, so I'll just ask here: Does anyone know what spark plugs are specified for the Mercruiser 7.4 MPI engines on my 406. They are probably 1999 engines instead of 2000.

When recommissioning this spring, we found out that the shower control lever was leaking. Looks like the washers in the cartridge dried out over the winter. Having a heck of a time finding a replacement cartridge or even a full shower control lever. Anyone else had to replace theirs or know of one that would work? Ordering one directly from Carver looks like it may take several weeks.

Saw this one on one of the Canadian marine stores website but can't tell if it will work.
When recommissioning this spring, we found out that the shower control lever was leaking. Looks like the washers in the cartridge dried out over the winter. Having a heck of a time finding a replacement cartridge or even a full shower control lever. Anyone else had to replace theirs or know of one that would work? Ordering one directly from Carver looks like it may take several weeks.

Saw this one on one of the Canadian marine stores website but can't tell if it will work.
...

Below are a couple of pictures of something on my 1981 3007 Aft Cabin. I have 2 of them. One is located in the main salon. The other is located outside on the bridge. What are they and what are they used for?

Does anyone know where I can find a used Walter V Drive possibly from a salvaged boat? mid 70's model Walter V Drive Ratio 2.05-1 part# RV-20D . Any and all advice is greatly appreciated. Thanks

My original AC unit, 1987 Carver Aft Cabin, has finally called it quits. Time to replace. Before dropping the $1500 for a new 16,000 BTU unit, I was going to ask experts out there is it really necessary to run AC all summer to help with the fiberglass hull of a boat? Heard opinions both ways. The reason I am asking was I was looking at getting a $400 portable unit that vents out the sliding window to use when I stay aboard and only run the unit when I am there vice all the time. I live in ...

My wife and I recently purchased our first boat big enough to spend weekends on. This model seems to have been set up for off shore fishing. It has the adjustable base for outriggers, but no further hardware than the base. Would any one know what would go into the bases?

I grew up on the Delta, then moved to Southern CA for many years. Now back in Stockton.

Anyone in the Delta area?

Hi Everyone!

I'm not new to boating...I grew up on boats.

Not new to boat ownership...I've owned 6 powerboats and 2 sailboats.

Not new to Carver, although this is my first Carver, I have owned her for 3 years now.

I lived on her for 2 1/2 yrs, in Huntington Beach and San Diego and now live with my wonderful new wife who loves "our" boat. We moved her to Stockton and now call the California Delta our boating home.



I love the 3007 for all the room in a 30 foot package...she a good looking very comfor ...

I'm so close to firing up my 350 mariner for the first time but for the life of me I can't figure out where the second hose for the prop shaft seals go.

Port exhaust riser_____prop seal____prop seal____????

Can any of you fill in the blank. Only one riser has a nipple for the hose to the water seal. I've checked all the manifolds and risers and can't find another.

Hi all, new to boating, got a 2000 carver 356 aft cabin. Replacing and fixing couple things. I have the full documents that came with it and could not find enough info on the issue at hand. The aft deck lights (2 pod's) and the stair light (outside just before the cabin door) is out. Bulbs are fine, so not sure what the problem is. Not sure which switch works them either. Any help would be greatly appreciated. I will be at the boat later this afternoon, will try to figure out but not sure ...