Hi,

I’m looking into a few ways to improve comfort on board, but without changing the original design too much. I’ve seen some modifications that stay visually clean while being useful, a bit like some watches or contemporary clock designs where design is both functional and aesthetic.

Do you have examples of small changes that really improve comfort while keeping a clean and consistent look?

I'm embarrassed to post this but here goes anyway. I didn't realize my old Voyager had transmissions. I thought the V-Drives were the transmissions and I've been diligent about checking the fluid levels in them and I've changed the fluid in them in the past. I'm not a boat mechanic but I can handle basic stuff like that along with oil changes, tune-ups, and winterization except for winterizing the closed loop cooling system. Since the boat has to be out of the water for that and I'm 2.5 hours aw ...

Hello,



i've posted a few times this past fall about us purchasing an '86 Mariner 36'. Not sure if this is the correct thread for this post, but here goes anyway.



We have been collecting parts and maintanance items to do do several projects this spring once we remove our shrink wrap and before we launch, and some other projects we'll do once we're in the water. This will be our first spring launch. We have had boats for many years, but always owned trailerable boats with outboards. This is our f ...

I have a 1992 carver 3608 and the aft cabin air conditioner controller got wet and shorted out the circuit board. I'm looking for either the complete controller#VRE6K-H or the circuit Board#FRM-300-X08.
If you have one or know where I can find one I would greatly appreciate the response.
Papa

Hello everyone,



Hope everyone is excited as me to get back on the water!



Getting ready to de-winterizing my boat. Last winter, winterizing for the first time since ownership, I realized my sea strainer basket is missing the bottom, motor 6CTA Cummins , anyone know the sea strainer part number? My cap on the Groco (I thnk it’s a Groco) is missing all the model number.



I called Groco with my measurements, and they told me the model number should be at the bottom of the bowl, I tried looking fo ...

greetings, tim & kim here from south jersey. we just purchased a 2008 carver cmy 41 with diessel engines. plan to keep it in cape may NJ.

So I don't have to go the lake and look, would anyone have the model type or manual for a Norcold refrigerator that came installed in a 1991 Carver 3607 Aft Cabin? I need to replace the freezer door to be specific. Thanks for any help

Hello all, I have a 59’ 2008 Carver Marquis. It has a GOST high water alarm, cameras and security. I can not find the main control panel for the system. I talked to a Representative from GOST and he told me, every technician puts them in different places. If anyone has suggestions, please help. I’ve looked under cushions in the salon, under the helm, engine room, closets, etc. thanks

I wasn't sure the best place to post this on the forums but I had to share. How big is the dash on a 360 Sport Sedan? Large enough for a 6' 4" (2m) man to fit inside.

Hi all, considering buying a 1997 Carver 500 with the Cummins 8.3's... Hope you can give me some advice? What material are the fuel and water tanks in this model? With 1000hrs, (1000hr service done) along with after coolers serviced, what should I be concerned with? Had numerous boats, just never a Carver. Thanks in advance.