GAS engine, transmission and generator repair and maintenance discussion forum.
0 Replies
146906 Views
Last post by CYO Admin
February 6th, 2013, 7:49 am
360 Replies
1421121 Views
Last post by waybomb
April 26th, 2026, 8:14 am
5 Replies
1886 Views
Last post by tonyiiiafl
July 25th, 2017, 5:03 am
Engine Hour Meter Running Fast
Replies: 10
by
crquisto »
June 21st, 2017, 10:20 am
I have a Carver 406 with twin 7.4 Mercruisers. I keep a log when I cruise and noticed on the last two cruises of around two hours each that my port...
10 Replies
5414 Views
Last post by Samuel
July 25th, 2017, 4:02 am
2 Replies
1796 Views
Last post by bud37
July 23rd, 2017, 8:10 pm
Cams, Pistons, Etc
Replies: 4
by
hausherrs »
July 18th, 2017, 4:01 pm
I am trying to source parts for an upcoming rebuild and im having a hard time finding stock spec parts. The cams are no longer available. And if they...
4 Replies
1805 Views
Last post by Viper
July 18th, 2017, 10:46 pm
where is my fuel shut off valve?
Replies: 3
by
MelvusMD »
July 17th, 2017, 11:13 am
Hello all:
3 Replies
2229 Views
Last post by Viper
July 17th, 2017, 9:42 pm
2003 360SS Repower
Replies: 5
by
taddly »
July 9th, 2017, 8:54 am
Just got the Wild Herron back from a re-power job. Replaced the troublesome Volvo Penta 5.7GXil-C engines with MerCruiser 383 MAG Strokers. Breaking...
5 Replies
2027 Views
Last post by taddly
July 10th, 2017, 10:25 pm
2 Replies
1579 Views
Last post by mjk1040
July 10th, 2017, 5:44 am
Type of oil?
Replies: 9
by
Bankerbiz87 »
July 4th, 2017, 11:13 am
We have 2 350 engines Crusaders should we be using a synthetic oil?
9 Replies
3127 Views
Last post by tomschauer
July 5th, 2017, 10:56 pm
Old fuel
Replies: 1
by
rmeyer03 »
July 1st, 2017, 10:32 am
I have a 1997 Carver 355 aft cabin...aux 30 gal fuel tank hasnt been used in couple of years...does fuel go bad and if so, should I drain or add...
1 Replies
1394 Views
Last post by Viper
July 1st, 2017, 10:45 am
9 Replies
2749 Views
Last post by mjk1040
June 29th, 2017, 5:53 pm
Carver 3326 crusader questions
Replies: 11
by
kileytaz »
June 19th, 2017, 12:43 pm
Afternoon all. Recently bought a 1979 Carver 3326 ( crusader 270's ) and made a 4 hr trip to her new home. Couple things that were off and would like...
11 Replies
3850 Views
Last post by tomschauer
June 23rd, 2017, 7:42 am
Volvo Penta 7.4L needed ASAP
Replies: 11
by
pitshop »
June 20th, 2017, 11:10 pm
Well, the good news is, we just bought a 2000 350 Mariner with only 300 hrs on port engine and 100 on starboard. Bad news is 300 hrs is all the port...
11 Replies
5270 Views
Last post by bud37
June 21st, 2017, 2:03 pm
504 needs coupling
Replies: 1
by
sltorpey »
June 20th, 2017, 2:29 pm
I need a coupling on my starboard side, I have been told they need to cut out the floor above the trans, in the salon to get to the trans bolts and...
1 Replies
1221 Views
Last post by hausherrs
June 21st, 2017, 12:34 pm
Red wire on back of alternator
Replies: 2
by
Helmsman »
June 29th, 2016, 8:24 am
I was checking fluid levels, etc. the other day and found a wire (red) laying unattached at the back of the alternator. I checked the other engine...
2 Replies
1723 Views
Last post by Helmsman
June 20th, 2017, 8:11 am
Walter V-drive Question
Replies: 13
by
amanphoto »
June 14th, 2017, 9:15 pm
I'm new to this and would like some clarification and info. I have a Walter direct mounted "V" drive. The oil has leaked out. My questions is where...
13 Replies
6976 Views
Last post by Viper
June 18th, 2017, 10:12 pm
Crusader 270 cuts out
Replies: 4
by
Carcare »
June 18th, 2017, 9:04 am
Hello, starboard engine starts and runs fine below 3000 rpm but when I run at 3400 rpm after 15 - 30 minutes sync gauge starts to jump to port then...
4 Replies
1873 Views
Last post by mjk1040
June 18th, 2017, 6:32 pm
Engine Temp Alarm
Replies: 9
by
SanJuanDreamer »
June 15th, 2017, 11:13 am
I have a 98 Mariner with Crusader 454xi.
9 Replies
2846 Views
Last post by Viper
June 17th, 2017, 1:20 pm
rinda techmate pro scan tool
Replies: 13
by
bud37 »
June 4th, 2017, 11:42 am
Heh there....do any of the Canadian guys out there have a current tech mate pro that they might consider selling???...Thanks ..
13 Replies
6166 Views
Last post by mjk1040
June 15th, 2017, 8:53 pm
310 Santego 5.0 liter twins
Replies: 5
by
Donald Claypoole »
June 2nd, 2017, 11:49 am
Hi there and so I'm new and still investigating this boat, and may have a really STUPID question...I've just discovered that port is replaced and...
5 Replies
2438 Views
Last post by km1125
June 7th, 2017, 3:34 pm
Generator rpm
Replies: 4
by
Jmatheson »
May 30th, 2017, 2:29 pm
My generator will not maintain rpm. It swings up and down continuously until sometimes it dies at the low end. This happens when it's on load or not....
4 Replies
1744 Views
Last post by Agriman
May 31st, 2017, 9:49 am
Raw Water Impellers
Replies: 13
by
mjk1040 »
May 23rd, 2017, 10:19 pm
So per Viper's advice I waited until launch and tackled the raw water impellers. Port engine was running at 140 degrees, but I was getting steam at...
13 Replies
5985 Views
Last post by g36
May 26th, 2017, 7:53 pm
2018 Boat Bucks
Replies: 8
by
RGrew176 »
May 12th, 2017, 10:49 pm
I am already planning how to spend some of my 2018 boating budget. I spoke with the mechanics at the new marina I am located at this year. I am...
8 Replies
2572 Views
Last post by bud37
May 14th, 2017, 5:54 pm
Loses power at 2000 RPM
Replies: 13
by
SharonAnne »
November 13th, 2016, 9:08 pm
Boat started losing power at the end of last summer (2015). Had carburetor rebuilt. This season we began by having fuel filter changed - but it still...
13 Replies
5421 Views
Last post by tomschauer
May 12th, 2017, 9:24 am
Fuel shutoff
Replies: 6
by
Helmsman »
May 4th, 2017, 12:00 pm
I have a 2006 Carver 33 SS with Crusader 6.0 l gas engines installed. I am planning to replace my fuel filters. My port engine rpm's are cycling up...
6 Replies
2258 Views
Last post by Helmsman
May 8th, 2017, 9:14 am
Heat exchanger end covers
Replies: 2
by
Ondercin »
April 29th, 2017, 10:09 am
So last year while putting the boat away I'd noticed a small crack in the cover plate of my heat exchanger (oem part number 44446)
2 Replies
1898 Views
Last post by mjk1040
April 29th, 2017, 7:27 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum
Sponsors