Welcome to Carver Yachts Owners Forum

We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com

You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

Push to start

Discussion of batteries, chargers, wiring, generators, distribution panels, battery switches, etc.
User avatar

Topic author United States of America
ataylor233
First Mate
First Mate
Posts: 101
Joined: October 10th, 2016, 11:08 am
Location: Detroit
Has thanked: 80 times
Been thanked: 6 times

Re: Push to start

Postby ataylor233 » February 9th, 2019, 7:54 am

Xx
Midnightsun wrote:Source of the post When I first thought this out there were several comments on another forum on how anyone could easily steal the boat. However I thought to my self nobody will figure out how the push buttons work as this is obviously a one of a kind. I also though about putting in a hidden switch which would either kill battery power or ignition to the switch. Nothing fancy or well hidden, in fact you could just use an unused accessory switch as nobody would know this switch activates the ignition circuit. Keys are so passé. :captain2:

If anyone feels that keys will prevent theft on a boat think again, the circuit is so simple anyone with minimal electrical knowhow can hot wire a boat in minutes. The newer boats and outboards are getting rather complex though.

2 jumper wires and access to the rear of the switch and I will have her started faster than you can pull the keys out of your pocket and use them. :-D



I agree besides I like to do things differently I also have insurance lol


Canada
darrenlife
First Mate
First Mate
Posts: 123
Joined: September 25th, 2018, 8:36 am
Vessel Info: 2002 Carver 410 Sport Sedan
Location: Peterborough, Ontario, Canada
Has thanked: 69 times
Been thanked: 36 times

Re: Push to start

Postby darrenlife » February 9th, 2019, 8:56 am

I had push button start on my last boat and thinking of doing this on my 410 as I keep thinking of the fatigue on the key ignitions (I do a lot of starting and stopping in the Trent Severn lock system)

The last boat had a master ignition key switch in the salon that had to be turned on which would engage power for the ignition switched on the helm. Just a little piece of mind.
User avatar

Canada
bud37
Admiral
Admiral
Posts: 4865
Joined: April 23rd, 2015, 10:22 pm
Has thanked: 579 times
Been thanked: 1210 times

Re: Push to start

Postby bud37 » February 9th, 2019, 11:31 am

darrenlife wrote:Source of the post

I had push button start on my last boat and thinking of doing this on my 410 as I keep thinking of the fatigue on the key ignitions (I do a lot of starting and stopping in the Trent Severn lock system)



In reality all the versions, button, toggle and key etc are all switches, subject to wear..there is even an off/on/momentary toggle.....really if you wear out a keyed switch ( think of your car here )...they can be replaced easily and cheaply from napa etc....just a simple off/on/start switch with keys has worked for me, You could install a lockable battery master for that matter....... :beergood:
The above is strictly my opinion.

Canada
Viper
CYO Supporter
CYO Supporter
Posts: 5975
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 455 times
Been thanked: 1671 times

Re: Push to start

Postby Viper » February 11th, 2019, 10:49 pm

There should always be an ignition on/off switch keyed or not, at the helm that is easily accessible in case of emergency. A lot of setups have primary ignition control switches with keys on the electrical panel in the cabin in addition to the on/off switch at the helm. This feeds power to the ignition circuit at the helm. Won't prevent the savy criminal from doing his thing but it's an added deterent, and what we're trying to do is make it as difficult as possible. The longer it takes a thief to steal something, the better the chances of him walking away.

Return to “Electrical”



Who is online

Users browsing this forum: No registered users and 74 guests