Carver Owners Forum

We are in the process of refurbishing the upper helm panels on our 1992 Carver 28 Aft Cabin. I need to replace the original aluminum dash and instrument panels to accommodate modern electronics.
Does anyone have any drawings of these panels that could be used for a fabricator?
Does anyone have a panel that was replaced, that still has the old panel?
Does anyone have a recommendation to have these replaced?
Does anyone know if there is any NOS panels available?

Any help would be greatly appreciated.

Thank You,
John

I redid my helm over the winter with a mix of stuff. I would think that the flat panel carbon fiber would look good with your setup/helm. Below is a pic and there is more on the carver revised thread in the project section



Matt