Hello. On my Carver 28 i have 2 different transmission cooler on is about 25cm long and the other 40cm long. Is there any reason or did someone just replace one with something that was easy to find?.
And where can i find the correct one with shipping world wide?.
Why i want to change is because the "End" on one of them popped off and seawater started flowing so i want to change both to have it done.
Welcome to Carver Yachts Owners Forum
We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com
You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
Transmission cooler
-
bud37
- Admiral
- Posts: 4918
- Joined: April 23rd, 2015, 10:22 pm
- Has thanked: 584 times
- Been thanked: 1227 times
Re: Transmission cooler
Are you sure they are both for the transmission ? Does the other engine have the same set up with two coolers ? Double check where the lines come from and go to.
FWIW.....The above is just my opinion..... 
-
Oldie
- Scurvy Dog
- Posts: 10
- Joined: March 28th, 2018, 2:01 am
- Vessel Info: 1977 28' Santa Cruz
Single screw v drive - Has thanked: 2 times
- Been thanked: 2 times
Re: Transmission cooler
I have a 1977 Carver 28, single engine with V drive. The raw water enters the "Walter" drive first then continues on to an in-line cooler for the Velvet drive, then on to the engine.
This appears to be the factory configuration and works well. From memory, my transmission cooler is around 25cm long. Not sure why you have 2 coolers.... maybe there were cooling problems at some stage?
This appears to be the factory configuration and works well. From memory, my transmission cooler is around 25cm long. Not sure why you have 2 coolers.... maybe there were cooling problems at some stage?
-
Viper
- CYO Supporter
- Posts: 6021
- Joined: July 10th, 2015, 9:58 pm
- Vessel Info: 1989 Carver 3807 Aft Cabin
- Location: Ontario, Canada
- Has thanked: 457 times
- Been thanked: 1687 times
Re: Transmission cooler
Typically if there's two coolers, one is for the transmission and the other is for engine oil. Engine oil cooler's are common on big block applications but can also be found on some small blocks as well. The U shaped dual cooler typically found on Crusaders is an example of two coolers in one (for trans and engine) but some applications have single coolers for each oil system.
Do a Google search for Crusader coolers. There are a lot of OEM and aftermarket suppliers, I'm sure a few of them would ship overseas. Failing that, a local hydraulics supplier might also have a cooler that will do the job.
Do a Google search for Crusader coolers. There are a lot of OEM and aftermarket suppliers, I'm sure a few of them would ship overseas. Failing that, a local hydraulics supplier might also have a cooler that will do the job.
Return to “Gas Engines/Transmissions”
Who is online
Users browsing this forum: Google [Bot] and 21 guests
Sponsors