Boat listing to port

Anything related to the operation of your boat. Steering, Bilge Pumps, thru-hulls, bottom paint, etc.
User avatar
aives
Scurvy Dog
Scurvy Dog
Posts: 6
Joined: July 24th, 2013, 4:16 pm
Vessel Info: 2002 466 carver motor yacht
Been thanked: 1 time

Boat listing to port

Post by aives »

466 Carver 2002
Tends to list to port 3 to 4 inches
Gas tanks equal and we think general belongings balanced
Any ideas on what might cause this?
User avatar
waybomb
CYO Moderator
CYO Moderator
Posts: 2745
Joined: February 5th, 2013, 9:24 pm
Vessel Info: 1995 Boston Whaler Rage15
1987 3697 Carver Mariner
1988 Cougar 46 Kevlar Vee offshore
1969 15' Glasspar / 1967 Johnson Electromatic 85
Location: Saint Joseph,Mi
Has thanked: 69 times
Been thanked: 492 times

Re: Boat listing to port

Post by waybomb »

Don't know your layout, but where's the generator tank and is it full? Are the holding tanks on the centerline, if not, maybe you need to fill or empty depending on what side they are?
How much beer do you have in the fridge? Maybe not enough? Tools? Extra batteries?
I've seen these boats and they generally sit level, so it must be something you have control over.
Thanks
Fred
1969 Glaspar Avalon /1967 Johnson Electromatic 85
1987 Carver Mariner
1988 Cougar Kevlar 46' with triple blown 572 ci
1995 Boston Whaler Rage
Past - 1988 2807, 1989 4207 Aft
User avatar
Ramsport47
Commander
Commander
Posts: 376
Joined: February 10th, 2013, 7:13 am
Vessel Info: 1998 Carver 310 Santego
Has thanked: 72 times
Been thanked: 59 times

Re: Boat listing to port

Post by Ramsport47 »

I agree With Fred. I've never seen any 466 list, let alone that much. Three to four inches is quite a lot for a heavy boat like that. Even if things that you put on weren't balanced, it shouldn't list like that. I would check your fuel tanks...could be the gauge saying it's full, but it actually isn't. If you have selector valves, you could be drawing off of one tank and not the other. The only way to make sure both tanks are at the same level is to completely fill them. Then you'll know if it's the tanks, and if your gauges are working properly.
Kenny
1998 Carver 310 Santego
T-Merc 350 Mag MPI (300hp)
Port: Cedar Point Marina, Sandusky, Ohio
User avatar
PNGTaubada
Scurvy Dog
Scurvy Dog
Posts: 16
Joined: August 12th, 2013, 8:32 pm
Vessel Info: Carver 466 MY 2002
Has thanked: 1 time
Contact:

Re: Boat listing to port

Post by PNGTaubada »

Hi I have a 2001 466 with the same problem. Mine lists probably 2-3 inches to the port.
It lists a bit more when I have the tender on the back because the motor is on port side.
But other than that there's no reason why it lists so much but it does - fuel and everything else not way out of balance.
I was suggested to get counter-weights - lead pellets but I don't know.
User avatar
waybomb
CYO Moderator
CYO Moderator
Posts: 2745
Joined: February 5th, 2013, 9:24 pm
Vessel Info: 1995 Boston Whaler Rage15
1987 3697 Carver Mariner
1988 Cougar 46 Kevlar Vee offshore
1969 15' Glasspar / 1967 Johnson Electromatic 85
Location: Saint Joseph,Mi
Has thanked: 69 times
Been thanked: 492 times

Re: Boat listing to port

Post by waybomb »

Hope you both don't have soaked core on one side.
Thanks
Fred
1969 Glaspar Avalon /1967 Johnson Electromatic 85
1987 Carver Mariner
1988 Cougar Kevlar 46' with triple blown 572 ci
1995 Boston Whaler Rage
Past - 1988 2807, 1989 4207 Aft
User avatar
aives
Scurvy Dog
Scurvy Dog
Posts: 6
Joined: July 24th, 2013, 4:16 pm
Vessel Info: 2002 466 carver motor yacht
Been thanked: 1 time

Re: Boat listing to port

Post by aives »

waybomb wrote:Don't know your layout, but where's the generator tank and is it full? Are the holding tanks on the centerline, if not, maybe you need to fill or empty depending on what side they are?
How much beer do you have in the fridge? Maybe not enough? Tools? Extra batteries?
I've seen these boats and they generally sit level, so it must be something you have control over.

Generator on centerline, what do I check to see if full?
when boat was purchased did not receive any manuals. Have found an owners guide but not all things in boat are in manual. Needless to say the beer fridge is never full!!
Holding tanks centre to starboard.
Freshwater centre to starboard
Another thing, grey water does not have a deck plate for removal. does this mean it goes out of the boat automatically? Yet there is a grey water holding tank also. Owners book very vague
Thanks for any help!
User avatar
aives
Scurvy Dog
Scurvy Dog
Posts: 6
Joined: July 24th, 2013, 4:16 pm
Vessel Info: 2002 466 carver motor yacht
Been thanked: 1 time

Re: Boat listing to port

Post by aives »

Ramsport47 wrote:I agree With Fred. I've never seen any 466 list, let alone that much. Three to four inches is quite a lot for a heavy boat like that. Even if things that you put on weren't balanced, it shouldn't list like that. I would check your fuel tanks...could be the gauge saying it's full, but it actually isn't. If you have selector valves, you could be drawing off of one tank and not the other. The only way to make sure both tanks are at the same level is to completely fill them. Then you'll know if it's the tanks, and if your gauges are working properly.


Thanks will check gas gauges
User avatar
Lyndon670
Admiral
Admiral
Posts: 657
Joined: July 29th, 2013, 11:35 pm
Vessel Info: 2000 Carver 506
Volvo TAMD74EDC
Location: Georgian Bay
Has thanked: 124 times
Been thanked: 140 times

Re: Boat listing to port

Post by Lyndon670 »

If you goggle "Report from the bilge", you will see a blog from a captain that bought a 506 and had the same problem. The 506 is not much different than the 466. It turned out it was a design flaw and he had lead bars installed to offset the list. My 506 however, doesn't list.
Lyndon,
2000 Carver 506
FOXY JOE
Volvo 7.4TAMD
Queens Cove Marina
Georgian Bay, Ontario
User avatar
aives
Scurvy Dog
Scurvy Dog
Posts: 6
Joined: July 24th, 2013, 4:16 pm
Vessel Info: 2002 466 carver motor yacht
Been thanked: 1 time

Re: Boat listing to port

Post by aives »

waybomb wrote:Hope you both don't have soaked core on one side.


Wouldn't that have shown up on the survey?
User avatar
Lyndon670
Admiral
Admiral
Posts: 657
Joined: July 29th, 2013, 11:35 pm
Vessel Info: 2000 Carver 506
Volvo TAMD74EDC
Location: Georgian Bay
Has thanked: 124 times
Been thanked: 140 times

Re: Boat listing to port

Post by Lyndon670 »

The coring is above the water line, not below it. It is solid glass below the water line.
Lyndon,
2000 Carver 506
FOXY JOE
Volvo 7.4TAMD
Queens Cove Marina
Georgian Bay, Ontario
Post Reply