FOrward hatch replacement
- tonyiiiafl
- Admiral

- Posts: 902
- Joined: November 19th, 2015, 4:00 am
- Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
- Location: Cape Cod, MA
- Has thanked: 601 times
- Been thanked: 193 times
FOrward hatch replacement
With a few weeks to uncovering the old girl, I am planning on working under the shrink wrap this weekend and replace the forward Bowmar hatch. This was the one that was ripped off in the October Nor Easter here on Cape Cod. Getting the old one off will be a little tedious to break any adhesive that is holding it on.
However, what would you all suggest that I use as a sealer when I install the new hatch? Silkaflex? 4200?
Suggestions welcomed!
Thank you!
However, what would you all suggest that I use as a sealer when I install the new hatch? Silkaflex? 4200?
Suggestions welcomed!
Thank you!
- Midnightsun
- CYO Supporter

- Posts: 2984
- Joined: March 27th, 2016, 2:27 pm
- Vessel Info: The Midnight Sun
2007 41CMY
Volvo D6-370's - Location: Montreal, Canada
- Has thanked: 272 times
- Been thanked: 1193 times
Re: FOrward hatch replacement
I have always used Sikaflex for hatches and windows. This is what I was told to use way back and have always stuck with it (pun intended)
I would use a general one such as Sikaflex 291.
- tonyiiiafl
- Admiral

- Posts: 902
- Joined: November 19th, 2015, 4:00 am
- Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
- Location: Cape Cod, MA
- Has thanked: 601 times
- Been thanked: 193 times
Re: FOrward hatch replacement
Thank you. I have some that I was going to use for my solar install but uses 4200 instead. Hoping the old one comes off easily.
- tonyiiiafl
- Admiral

- Posts: 902
- Joined: November 19th, 2015, 4:00 am
- Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
- Location: Cape Cod, MA
- Has thanked: 601 times
- Been thanked: 193 times
Re: FOrward hatch replacement
I have a tube of 252 I was going to use on my solar install. What do you think of 252?
- Midnightsun
- CYO Supporter

- Posts: 2984
- Joined: March 27th, 2016, 2:27 pm
- Vessel Info: The Midnight Sun
2007 41CMY
Volvo D6-370's - Location: Montreal, Canada
- Has thanked: 272 times
- Been thanked: 1193 times
Re: FOrward hatch replacement
You may be overthinking this, 291, 4200 or 252 will work fine in your application. Just apply a small bead, just enough to seal out rain water. As long as it is not a permanent type like 5200 you will be on the right track. Sticking to the fiberglass is not an issue as anything will stick and the same goes for the hatch assuming it is aluminum. My hatch was plastic so silicone was out of the question however any of the 3 mentioned above would work well.
- bud37
- Admiral

- Posts: 5184
- Joined: April 23rd, 2015, 10:22 pm
- Has thanked: 604 times
- Been thanked: 1312 times
Re: FOrward hatch replacement
Just to add, clean the mating surfaces real well, especially if someone has put silicone of some type in there.... 
FWIW.....The above is just my opinion.
- tonyiiiafl
- Admiral

- Posts: 902
- Joined: November 19th, 2015, 4:00 am
- Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
- Location: Cape Cod, MA
- Has thanked: 601 times
- Been thanked: 193 times
Re: FOrward hatch replacement
Thank you. I do tend to keep things in the “design” stage too long before going into operation mode.
- tonyiiiafl
- Admiral

- Posts: 902
- Joined: November 19th, 2015, 4:00 am
- Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
- Location: Cape Cod, MA
- Has thanked: 601 times
- Been thanked: 193 times
Re: FOrward hatch replacement
DONE. 1.75 hours. That Silkaflex was brutal to squeeze out of a caulking gun!
Out with the old inWith the new. Our hatch was destroyed during the October 2021 storm. Finally got a replacement and the installation went great. Yes prep is 99% of the success. And I added the Bomar combo shade/screen inside piece. No more insterting screen and also can use shade to keep sun out during the hot days of summer. One step closer to launch day. Yes Admiral is happy as she got the new hatch and the combo sceeem shade. Always keep the admiral happy. Always.
Out with the old inWith the new. Our hatch was destroyed during the October 2021 storm. Finally got a replacement and the installation went great. Yes prep is 99% of the success. And I added the Bomar combo shade/screen inside piece. No more insterting screen and also can use shade to keep sun out during the hot days of summer. One step closer to launch day. Yes Admiral is happy as she got the new hatch and the combo sceeem shade. Always keep the admiral happy. Always.
You do not have the required permissions to view the files attached to this post.
-
Viper
- CYO Supporter

- Posts: 6266
- Joined: July 10th, 2015, 9:58 pm
- Vessel Info: 1989 Carver 3807 Aft Cabin
- Location: Ontario, Canada
- Has thanked: 475 times
- Been thanked: 1791 times
- RGrew176
- Admiral

- Posts: 6652
- Joined: August 17th, 2015, 4:07 am
- Vessel Info: 2023 SunTracker Party Barge 22 DLX
- Location: Southgate, MI.
- Has thanked: 72 times
- Been thanked: 470 times
Re: FOrward hatch replacement
Looks good. Nice job.
Rick Grew
2025 Godfrey Xperience 2286 SFLX
2004 Past Commodore
West River Yacht & Cruising Club
2025 Godfrey Xperience 2286 SFLX
2004 Past Commodore
West River Yacht & Cruising Club