As I am a proud owner of a 1994 39' CPMY, sadly it is in Maine resting for the winter and I am on Cape Cod, MA. I am reayding to buy my zincs, but don't have the sizes. Does anyone know:
1) The shaft size
2) Transom zinc size
3) Trim Tab zinc size
Thanks in advance!
Tony Lacina
Specs for 39' CPMY
-
tonyiiiafl
- Admiral
- Posts: 902
- Joined: November 19th, 2015, 4:00 am
- Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
- Location: Cape Cod, MA
- Has thanked: 601 times
- Been thanked: 193 times
-
SHEMP
- Deck Hand
- Posts: 51
- Joined: March 7th, 2013, 7:43 pm
- Vessel Info: 2000 CARVER 456 MY
Full Bridge and aft deck enclosure
Originally purchased in Staten Island
Second owner also purchased in Staten Island in 2012
Now berthed in Toronto Canada
A wonderful and fully appointed luxury yacht. - Location: Toronto Ontario Canada
- Has thanked: 7 times
- Been thanked: 4 times
Re: Specs for 39' CPMY
Hi Tony
I don't know the size for your boat , but when I hauled my 456 , the marina that did my work , easily found all the zincs you mentioned. Fairly inexpensive as i recall. I'll look for my invoice and will give you my details.
Victor
I don't know the size for your boat , but when I hauled my 456 , the marina that did my work , easily found all the zincs you mentioned. Fairly inexpensive as i recall. I'll look for my invoice and will give you my details.
Victor
-
tonyiiiafl
- Admiral
- Posts: 902
- Joined: November 19th, 2015, 4:00 am
- Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
- Location: Cape Cod, MA
- Has thanked: 601 times
- Been thanked: 193 times
-
tonyiiiafl
- Admiral
- Posts: 902
- Joined: November 19th, 2015, 4:00 am
- Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
- Location: Cape Cod, MA
- Has thanked: 601 times
- Been thanked: 193 times
Re: Specs for 39' CPMY
also, how many do you have on the shafts? I have seen 1, 2 and 3 on the shafts. Can you "over zinc"?
-
Viper
- CYO Supporter
- Posts: 6266
- Joined: July 10th, 2015, 9:58 pm
- Vessel Info: 1989 Carver 3807 Aft Cabin
- Location: Ontario, Canada
- Has thanked: 475 times
- Been thanked: 1791 times
Re: Specs for 39' CPMY
tonyiiiafl wrote:Qr Bbpost ....Can you "over zinc"?
I don't think you can with zinc but you can with magnesium in fresh water applications.
-
AaHubb
- Commander
- Posts: 315
- Joined: February 16th, 2013, 5:46 pm
- Vessel Info: '99 404 CPMY
my twin diesel pusher - Location: Kennewick, Wa
- Has thanked: 15 times
- Been thanked: 61 times
Re: Specs for 39' CPMY
Don't know if it applies to your boat, my '99 404 cpmy has 1.5 inch shafts with two zincs each.
..Aaron
..Aaron
'99 404 CPMY
SeaDragon
SeaDragon
Sponsors