Carver Owners Forum

Welcome to the forum......just a guess here, but I think the button is providing the start function and the key is the run power.....maybe a type of anti theft device or just filling in for the solenoid/relay. Those two things are generally provided by the key switch itself, off, run, start.

If you can check volts across the button, then try to jump across the button terminals and see if the switch works as normal....like your car...that should give you an idea. If you aren't comfortable get a marina tech to check that for you......good luck with it.

km1125 wrote:Qr Bbpost

Midnightsun wrote:Qr Bbpost

Johnnymalibu wrote:Qr Bbpost
yes you push it in to start then release it .
yes we have a key

Need more info. Do you turn the key to on then push the button until it starts and then release the button once started? To turn off do you simply turn off the key?

And what happens at the lower station... does it have a key also?

yes it has a key , it will not work unless someone goes up on the fly bridge and holds the button in

Is this a single engine or dual engine? If a dual, is there a separate push button for each engine?

It is diesel or gas?

km1125 wrote:Qr Bbpost Is this a single engine or dual engine? If a dual, is there a separate push button for each engine?

It is diesel or gas?

single engine , gas

bud37 wrote:Qr Bbpost Welcome to the forum......just a guess here, but I think the button is providing the start function and the key is the run power.....maybe a type of anti theft device or just filling in for the solenoid/relay. Those two things are generally provided by the key switch itself, off, run, start.

If you can check volts across the button, then try to jump across the button terminals and see if the switch works as normal....like your car...that should give you an idea. If you aren't comfortable get a marina tech to check that for you......good luck with it.

Thank you

Thank you

Well, this sounds very strange. Seems like someone needs to get under both helms with a voltmeter and take some measurements on the back on each key switch.

I would say it's a bad key switch, but that means you would have TWO bad ones (one up and one down). The fact that there's a button next to one that you can push means that all the "signals" are available at the key switch to work correctly, as that button should have the same function as the temporary "start" position on the key switch. Also rules out a bad solenoid or start relay somewhere else.