I own a 2000 406 and I am searching for the USCG Official VESSEL PLACARD. I thought one was supposed to be on the boat but I can not find one so far. Any advice will be appreciated.

Hi all, we are so excited as we just recently purchased a 1987 Carver 4207. We've been going through many changes and so far seem to be handling things one at a time.

One thing that did come up is in regards to replacing the upper helm gauges. I know the sizes are standard and I did do a forum search here...

My question is, do I really need new sending units?

I'm looking at all new Faria gauges and just the basic ones (tach, temp, alt, fuel, oil pres...) and am hoping it's just a simple swap out.. ...

Purchasing a 2003 Carver 450 Voyager pilothouse. would like to purchase/install Splendide stackable washer/dryer. looking for advice on where to run 4 inch dryer vent and best place and type of thru wall vent

After coming back to my boat after two months I discovered water under my port engine. This is the first time water has pooled under the engine, I have always had some water in the bilge. I started investigating and found wet carpet under the couch against the port wall. I removed the two panels on the wall - one for access and the other for 'extra battery' (and I am really glad there was not a battery there) - the board in the battery compartment was very wet. There is a round access cap toward ...

Need to remove the forward head but I cannot locate the water intake. Any have information on where it would be and how to access it?

Thanks for any help!

I have a Kohler generator and not getting fuel to the fuel filter. I have replaced all fuel lines, fuel filter, fuel pump and main circuit board. also the remote switch does not work as well but did work before this issue. I have had a mechanic isolate the pump and use a gas can with about 5’ of line attached directly to the fuel pump and turns right over and runs. The run from my fuel tanks to the generator is about 10-15 feet. The board is not producing 12 volts when tested in the starting pro ...

Oh MY!!!

Interior LED light covers.Have searched high and low and even bought items that looked to fit only to learn that they did not. If anyone knows of a source for these covers please let me know. The original manufacturer seems to be a company named HERA but have yet to locate the size and design that snaps into place over the light. I could not load images here for some reason here is a link in facebook. TIA!

https://www.facebook.com/groups/31258280440

Hi folks, this is my first post on the forum. I purchased a 2003 366 Carver a little over a year ago and I am updating and cleaning up issues. My hot water heater is located under the bed in the aft cabin. The hot water tank appears to have been leaking for some time. I believe I can change the hot water heater out ok. What I need help with is the wood under the hot water heater. You can see from the attached pictures that the plywood the tank sits on has become rotten. I am nervous to go ...

Hi team-Carver!

Hope all is well with everyone! As I continue to ready my new (to me!) 2001 466 MY for my first season on the water, I have noted that my boat is quite naked, that is to say, it has none of the original Carver Logos and almost none of the original pinstriping (the boot stripe is there and in good condition - the rest are gone). I am not too concerned about the pinstripe - I can get what I need pretty much anywhere. The logos are another matter.

I have found the correct "CARVER" ...