Hi,
I am looking for the hardware that holds the swim ladder to the boarding ladder of a 89 aft cabin. I have googled it but apparently I am not using the correct term.

Thanks
Mitch

This is kinda funny. Good thing is it can easily be removed if you choose or as it weathers.

https://www.stickers-factory.com/danger ... 13500.html

Hi all I have carver 320 1992 with two Volvo Penta tamd31 I get full revs under load 3900 rpm
gearbox ratio is 1.93 prop size 18x15 can only get 10 nots no vibrations everything runs sweet
top speed not good

So I have a 1976 mariner with twin mercruiser 233 with no sea strainers. Want to install them before i put it in saltwater. What size do I need? Thanks.

Hello. I’ve removed and replaced 3 of the 4 exhaust elbows on the Crusader 350XLs in our 95 325 Aft Cabin. The fourth, the one on the far port side, I have no clue how to remove. There are two bolts in the front and two studs in the back. For the other three, I just removed the bolts and nuts and lifted them straight up off the studs. But the fourth sits about an inch under a non-removable support beam, with maybe a mm of clearance. I tried to see if I could pull it out towards me, while p ...

Does any one have the exact dimensions or maybe a link where Carver Yacht drawings specs could be found for a 1987 Carver 4207 gas fuel saddle tank.
I have what was provided to me from the former owner but the numbers do not allow for the proper 200 gal capacity and the boat is 3 hours away from me.
I am trying to get them to has a new tank fabricated to replace a leaky tank.
Thanks in advance for the help as always!
David

Look what arrived on my doorstep today!

I have a new set of props and a shaft for a Carver C52. We bought them for a trip and ended up not using them. I’m trying to figure out how to price them and where to list them. We don’t want to pay for shipping. Any advice?

Hello to all our fellow Canadian boater friends. My wife Tracy and I have recently purchased our new to us Carver 444. We would like to talk with any members who have gone through the Transport Canada Boat Registration process. We have spoke to TC officials on numerous occasions trying to make sure our forms are correct. We are getting different responses surrounding our tonnage calculations. If anyone has successfully navigated this process we would really like to chat. Our situation is because ...

I replaced both sending units on 32 foot carver montego.



They worked great when I tested them before I installed them in the gas tanks



Now they always read half full no matter have much gas is in the tank...full or almost empty



Any ideas on how to fix them or adjust them...



I bent them and use the exact length as the old ones that I removed.



Also the port side tank looks like it is smaller that the starboard side, if that matters at all



thanks



Steve