Hello to all our fellow Canadian boater friends. My wife Tracy and I have recently purchased our new to us Carver 444. We would like to talk with any members who have gone through the Transport Canada Boat Registration process. We have spoke to TC officials on numerous occasions trying to make sure our forms are correct. We are getting different responses surrounding our tonnage calculations. If anyone has successfully navigated this process we would really like to chat. Our situation is because ...

I replaced both sending units on 32 foot carver montego.



They worked great when I tested them before I installed them in the gas tanks



Now they always read half full no matter have much gas is in the tank...full or almost empty



Any ideas on how to fix them or adjust them...



I bent them and use the exact length as the old ones that I removed.



Also the port side tank looks like it is smaller that the starboard side, if that matters at all



thanks



Steve

I recently purchased a 2000 506 and need to add a davit of some sorts for our Gala v360 dinghy with 40hp (550lbs). I’m considering a Hurley H3O+ on an extension off the stock swim platform. Does anyone know what max weight the platform will support, or has anybody had success hanging a large tender like this off the back of a 506 platform? I’m trying to determine if I should add any support before installing.

Good Day All,

Time for some preventive maintenance. Welcome any input on the best price/quality risers and elbows for the CM 350HT, V-8.
We are located in Canada, but open to US suppliers as well. Had a quote the other day, that just seemed high. Looking for some comparisons, but as with everything else this might be the normal increase in prices.

Thanks in advance for all replies. cheers

Good Day All,

What do the members' considers to be the best plug and wires for the CM 350HT, V-8? Time to replace.

Good Afternoon Everyone.
I have a question about Fuel Tank replacement for a 1987 4207. I already know all the difficulty with the saddle tanks and engine pulling etc. There is a great form on this in here. But, I was just wondering if anyone has used or know of someone that has used a bladder, or maybe a bladder insert or something like this to do the repair. If so if anyone has a link to info or where to buy or research such a thing. Thanks in advance!!!!

All, I am looking for the dimensions for my Carver 390 aft cabin mattress. I cannot go and measure
myself as the boat is not accessible under 3 feet of snow.
any help much appreciated.

Hello. I am looking for a source to buy porthole screens for a 2006 Carver 35 SS. Thanks, Rose

Hey All,
I have a 98 Carver 350 Mariner. In the salon on the starboard side of boat I have cushions that pull out with folding legs attached below so I can establish an additional sleeping area. One of the legs is broken and I'm trying to find a replacement and would appreciate any suggestions on where I may find the same part or a suitable replacement. Appreciate any guidance or suggestions. Thanks

Hello,

I'm looking for some guidance to the salon table dropping down for the cushions to fit as a sleeping area on my Carver 350. Can you provide any help with how the table lowers enough to fit into the edges of the seat frame so I can place the designated cushions down? Logically, it looks like I just loosen the screw that adjust the height of the table and then drop it down, but when I do this the table doesn't go down far enough to seat in the correct location. Another member said he removes ...