New to me 2009 44 Sojourn.

Both tanks indicate empty all the time.

Water tank completely full - still shows empty. Tank is clean.

Holding tank about 3/4 full - still shows empty. Tank is not very clean on the inside.

Both tanks are plastic.

Sensor system is the SensaTank II system using the probeless external sensors attached to the outside of the tank.

All wires appear to be original to the boat and all solder joints and stuff look to be in good condition.

I have not pulled the actual gauge and ver ...

I have two like new 22x22 Michigan Wheel bronze DQX props. One is right hand, the other left hand. I bought them new last January, arrived in March. I used them for 9 miles, while I had my old props straightened.



After pulling them, I had them assessed and straightened at Performance Propeller in Soddy Daisy. They were apparently slightly out of round from shipping or when they were installed by the diver. Anyway, they are in the original packaging and ready for shipment. New ones are $3800 plus ...

I'm interested in a boat located in Toronto. Problem is I am in Philadelphia and there is no way to see the boat in person until the travel restrictions are relaxed and who knows when that will be. So my question is does anyone live in the Toronto area that would be interested in looking at a boat for me? It's on land, shrink-wrapped with a zipper and I just want an unbiased set of eyes on the boat. Pictures of the cushions, helm area, interior, etc.

Thanks!

I’m a new carver 42 SS owner. How or where is the gauge that’s tells me how much water is in the grey water tank. I have read the owners manual but there’s no information on this.

Hello Captains,
Need some help. I have the original Hynautic H-50 helm with RV-55 Reservoir on my 1989 Santego. Does anybody have the exact Sea Star replacement information? I have spent quite a bit rebuilding the Reservior and rudder cylinder and now the helm is grinding. I want to replace the entire system without too many alterations and get away from the “Reservior” system.
Thanks, Greg

Can anyone tell me how to access the starboard shaft seal on a 1996 Carver 355?

Have a Carver 50 with a full hard enclosure on the deck behind the helm. We were in an accident and a few of the windows were broken. Anyone know who manufactured the windows for Carver? Typically this area has a canvas enclosure, but ours has the hard structure. I do not know if this was done by Carver or aftermarket. Any help would be appreciated.

Happy New Year.

I've long been looking for a transom/swim platform storage box. Thus far, I've been unable to find an aftermarket source for these. Does anybody have a suggestion?

I’m looking for a carver 42-48FT and have you to $200,000 to spend. If you’re thinking of selling please send me a message thank you

I’m new and want to buy a carver 42-48FT and have a budget from $100,000 USD to $200,000 USD