It was time to replace the original Halon horizontal Fireboy in the engine room on my 1994 390CPMY. However, no more halon, so it is some FK-5-1-12. It is longer and heavier, so there is no way it will fit against the forward bulkhead horizontally. It does say mouth vertically anyway. I have room in front to the port engine (454 Gas) that will allow it to go vertically. However, it would need to go into the outer stringer. I know they are all fiberglass. I was thinking of a 3/4” PT plywood, with ...

Hello everyone,

My wife and I are looking at a 2000 Carver 396 Motor Yacht. 1400 hrs on the engine and just short of 3000 on the generator. Anything specific we should look out for or take extra care looking at before we make an offer?

TIA,
Greg

Taken off my Carver 506. Beautiful Condition, Original Chair. $125 plus shipping.
THIS ITEM IS SOLD.

Last Summer we boated 1 hour to dinner then docked with GenSet running. 1.5 hours at dinner then were returning home when some dash warning lights came on for the stbd engine. These indicators were 5 graphic lights depicting engine overheat and other scary things. The digital gauge readout was normal but I still had to check the engine room. All seemed normal there too. I restarted both engines and the lights did not turn on again or since. MY QUESTION: What system controls these warning l ...

I have a '92 Carver 33 Aft Cabin. When taking the bimini off to get it replaced I trashed the anchor mast light. Can anyone tell me what make or model it may be. The round base is about 2.5"[image][/image]

I think I posted the pictures correctly. . .
TIA

Matt

Considering a 2000 326. Have read some less-than-flattering reports about it being top-heavy and unstable. I've read reports of considerable bobbing motions, even at dock/anchor. I realize these boats are floating condos, but is the stability really this bad? Carver sure seems to have sold many of this design over the years for the handling to be so terrible.

Looking for Carver C40 Command Bridge. Prefer low hours, hard top, laminate flooring but open to others.

I'm looking to install Hull Shield on our boat to discourage marine growth. It only works, however, if the associated transducers are mounted directly against the hull below the waterline with no intervening insulation or sound absorbing material.



If necessary, I can mount them on the outside of the transom, but I'd prefer to mount them on the inside of the hull if possible.



The owner's manual says that balsa wood was added to the hull on the "planing surface" and to the hull sides "where necessar ...

My Cat 3208 Engine pan gasket started leaking. Has anyone had to change this gasket. If so were you able to do so without removing / raising engine.

Looking for a clean, low hours 504.