Shore water

[Carcare]

Hi new guy just bought 1984 3207. When I turn on my water pump water shoots out my shore water inlet ?

[g36]

You have a bad check valve at the shore water connection
You might take it apart and get lucky there's something keeping the unit from sealing or you will need to replace it.

[Viper]

Welcome aboard, and congrats on the new purchase.

Replace the water inlet.

[Carcare]

Thanks, I'll get a new valve Monday.

[waybomb]

Welcome aboard!

[mjk1040]

Our 1986 Mariner didn't have check valve built into the inlet for shore water. You had to cap it when you ran the onboard pump. I ended up buying a shark bite check valve and put it in the line after the inlet fitting, thus no more need to cap it. Also, you can purchase a pressure valve at any Walmart in the camper section if you shore water pressure is to much for your existing plumbing. The newer inlets being sold today I do believe have the pressure regulator and check valve built into them. Mike Lot's of options!

[Viper]

You're right Mike, most of the older units did not have check valves in them so could indeed be just that it needs a cap or seal depending on the current type. Some older apps such as mine have a remote check valve/regulator. You wouldn't know it's there by simply removing the inlet fitting as the regulator is hidden behind the starboard wall panel behind the couch.

If you have one of these:
http://www.defender.com/product3.jsp?pa ... id=2410648 there is a regulator/check valve built in and if leaking, it needs to be replaced.
If you have one of these:
http://www.westmarine.com/buy/seafit--w ... cordNum=21
there may or may not be a check valve behind it.

[mjk1040]

Viper, that style from defender go bad? The one like that on our '98-355AC/MY seems to be holding back too much pressure and sometimes after re-hooking it up after a cruise it squeals and make noises and the pressure at the facets is low. Mike

[Viper]

Ya they go bad. If you can 't get the same amount of pressure or more than your on-board pump, then it's likely time to replace the fixture. Most common cause of failure is improper winterizing but like anything else, they'll fail just because it's time.

[mjk1040]

Thanks 4 the reply! Mike