spotlight

nightsky · Post by **nightsky** » March 25th, 2017, 12:25 am

waybomb wrote:Qr Bbpost Run power from your dc panel to the light, but get a RF remote control light???????

That may be an option worth looking in to. Thanks.

SplashyLady · Post by **SplashyLady** » March 25th, 2017, 1:53 pm

Or you can get a nice LED handheld for $50 - https://www.amazon.com/Stanley-SL10LEDS ... +spotlight

nightsky · Post by **nightsky** » March 25th, 2017, 1:59 pm

SplashyLady wrote:Qr Bbpost Or you can get a nice LED handheld for $50 - https://www.amazon.com/Stanley-SL10LEDS ... +spotlight

That's what I have been thinking too.

Lyndon670 · Post by **Lyndon670** » March 25th, 2017, 6:06 pm

Do it right...I have always learnt that trying to do it the easy way or cheap way doesn't pay off in the end.

bud37 · Post by **bud37** » March 25th, 2017, 6:40 pm

Is it possible that the factory wiring was installed in the railing there, just not used.

mjk1040 · Post by **mjk1040** » March 25th, 2017, 11:15 pm

If the breaker in fact has wiring on it, it would be my guess that that wiring may just run up to the bridge panel where the spot light control would have been installed. So I would pull the DC panel to see if in fact wires are on this spot light breaker, then trace them out, checking the bridge panel behind the front bridge seat. If it leave there I too would guess the wiring should be in the rode locker. Mounting could be on the bow pulpit or the bow rail. Mike

nightsky · Post by **nightsky** » March 26th, 2017, 1:41 pm

Lyndon670 wrote:Qr Bbpost Do it right...I have always learnt that trying to do it the easy way or cheap way doesn't pay off in the end.

That begs the question, what is the right way? Why would using a handheld be wrong?

nightsky · Post by **nightsky** » March 26th, 2017, 1:43 pm

mjk1040 wrote:Qr Bbpost If the breaker in fact has wiring on it, it would be my guess that that wiring may just run up to the bridge panel where the spot light control would have been installed. So I would pull the DC panel to see if in fact wires are on this spot light breaker, then trace them out, checking the bridge panel behind the front bridge seat. If it leave there I too would guess the wiring should be in the rode locker. Mounting could be on the bow pulpit or the bow rail. Mike

I have no spotlight breaker at all.

km1125 · Post by **km1125** » March 26th, 2017, 2:08 pm

nightsky wrote:Hi all. I have a '94 390 that has a breaker on the DC panel for the spotlight, but my boat doesn't have a spotlight installed.

nightsky wrote:Qr Bbpost
I have no spotlight breaker at all.

Did I read both of those correctly?

nightsky · Post by **nightsky** » March 26th, 2017, 6:04 pm

km1125 wrote:Qr Bbpost
nightsky wrote:Hi all. I have a '94 390 that has a breaker on the DC panel for the spotlight, but my boat doesn't have a spotlight installed.

nightsky wrote:Qr Bbpost
I have no spotlight breaker at all.

Did I read both of those correctly?

You are right, my bad. Back to chasing wires down the races.

spotlight

Re: spotlight

Re: spotlight

Re: spotlight

Re: spotlight

Re: spotlight

Re: spotlight

Re: spotlight

Re: spotlight

Re: spotlight

Re: spotlight