Generator rpm

GAS engine, transmission and generator repair and maintenance discussion forum.
Post Reply
User avatar
Jmatheson
Scurvy Dog
Scurvy Dog
Posts: 5
Joined: July 9th, 2016, 12:40 pm
Vessel Info: 1997 carver 405 aft cabin
Has thanked: 4 times

Generator rpm

Post by Jmatheson »

My generator will not maintain rpm. It swings up and down continuously until sometimes it dies at the low end. This happens when it's on load or not. Thanks.
User avatar
tomschauer
Admiral
Admiral
Posts: 2323
Joined: March 28th, 2016, 10:52 pm
Vessel Info: 1998 Carver 355
Suspicious Fishes !
2022 Kawasaki 310X
Location: upper chesapeake bay
Has thanked: 326 times
Been thanked: 602 times

Re: Generator rpm

Post by tomschauer »

It may be as simple as a governor spring unhooked. If you post a model number, someone most likely has a manual.
User avatar
bud37
Admiral
Admiral
Posts: 5182
Joined: April 23rd, 2015, 10:22 pm
Has thanked: 604 times
Been thanked: 1312 times

Re: Generator rpm

Post by bud37 »

If this is a gas generator......Could also be a partially restricted jet causing the engine to run lean,( hunting ) by the sounds of your explanation .....also there is an adjustment for idle mixture on the carb which may help a bit , but you need to read the manual to adjust only the mixture screw.....never adjust anything to do with rpm........ :beergood:
FWIW.....The above is just my opinion.
User avatar
km1125
Admiral
Admiral
Posts: 3657
Joined: February 28th, 2017, 6:04 pm
Has thanked: 81 times
Been thanked: 1114 times

Re: Generator rpm

Post by km1125 »

How long have you run it? What kind of load do you run it on?

If it's not something simple (like the spring) then definitely sounds like a fuel condition. These don't typically get run a lot, so you can end up with carb issues from lack of use.
User avatar
Agriman
Deck Hand
Deck Hand
Posts: 76
Joined: April 9th, 2013, 1:58 pm
Vessel Info: 1998 Carver 350 Mariner Twin 454 Crusaders
Location: Chatham, On.
Has thanked: 5 times
Been thanked: 5 times

Re: Generator rpm

Post by Agriman »

Is the water pump showing good volume flow? Low water volume will cause the generator sensor to shut down to protect the unit. You might need a new impeller.
Post Reply