Welcome to Carver Yachts Owners Forum

We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com

You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

drive line

ImageThis forum is for general discussion of all things Boating. If it's boating related and doesn't fit in another forum, post it here!
Post Reply
User avatar

Topic author United States of America
robertstinson617
Scurvy Dog
Scurvy Dog
Posts: 1
Joined: April 30th, 2017, 9:29 pm
Vessel Info: 1988 carver Santiago 38
Location: san francisco

drive line

Postby robertstinson617 » August 19th, 2017, 3:10 am

I have a 1988 carver Santiago and I was having the bottom cleaned and the diver told me that my Port side prop was touching my rudder some how the shaft slidout. What would cause this to happen would appreciate any advice on subject.
Top

User avatar

United States of America
km1125
Admiral
Admiral
Posts: 3500
Joined: February 28th, 2017, 6:04 pm
Has thanked: 69 times
Been thanked: 1043 times

Re: drive line

Postby km1125 » August 19th, 2017, 8:44 am

I can't imagine how it could slide that far out and still be attached! It could slide a little if the coupling at the transmission wasn't correctly installed. Normally you would drill pilot "dimples" into the shaft once you've located where the set screws will 'land' then tighten the set screws into them, so that the shaft can NEVER pull out.

Did you do a recent hard backing on that engine? I had a friend do that one time and his shaft came out, similar to yours. It was due to improper installation.
Top

Canada
Viper
CYO Supporter
CYO Supporter
Posts: 5975
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 455 times
Been thanked: 1671 times

Re: drive line

Postby Viper » August 19th, 2017, 7:27 pm

Welcome aboard.

A picture of the type of coupler you have would help determine the cause. A bad alignment, poor hardware condition and bad install practices will all contribute to the problem.
Top
Post Reply

Return to “General Boating Discussion”



Who is online

Users browsing this forum: No registered users and 39 guests