Wayne162 wrote:Qr Bbpost Update - My sundeck panels have been made and are ready to be installed after the holiday. I gave up on the poly panels and went with custom marine grade aluminum panels (Cost less), and powder coated them to match the boats existing shade of white. I replaced the original single stripe at the base of the panels as it was dated and boring. Instead I decided to spice her up a bit with a custom wave design using black and gold-leaf graphics. I also tinted the salon and galley windows with 5% tint with 100% UV protection for full side and forward viewing without having a snap down cover across the front windows. Attached are photo's of the new sun deck panels with graphics that were applied to the panels today. When I get them installed on the boat, I will post additional photographs of my project.
Hi ataylor233, I have one existing panel originally from the starboard side. I had not thought about selling it but its only going to sit in the garage. If your interested, I think $50 would work, plus shipping. I priced a new poly panel at $400 before any cuts were factored in.
Attached are photos of the finished side panels. Corners have not been installed yet, and the aft port panel was measured to manufactuer an aluminum one.
You do not have the required permissions to view the files attached to this post.
Sponsors