2000 356 propeller shaft size

AnamCara · Post by **AnamCara** » March 12th, 2018, 4:37 pm

Does anyone know the propeller shaft size on a 2000 356 with 7.4l Crusaders?

tomschauer · Post by **tomschauer** » March 12th, 2018, 5:55 pm

My 355 with 7.4's has 1 3/8 shafts.

AnamCara · Post by **AnamCara** » March 12th, 2018, 9:01 pm

Thanks fro the quick reply, I was looking up specs on the boat and it states that they should be 1 3/8 . I stopped down to a marina by home and measured the shafts on a 355 and a 356 both with Merc's and they were both 1.5 in. I guess I'll have to wait to check the boat itself, only problem its 5 hours away.

bud37 · Post by **bud37** » March 12th, 2018, 9:20 pm

AnamCara wrote:Qr Bbpost Thanks fro the quick reply, I was looking up specs on the boat and it states that they should be 1 3/8 . I stopped down to a marina by home and measured the shafts on a 355 and a 356 both with Merc's and they were both 1.5 in. I guess I'll have to wait to check the boat itself, only problem its 5 hours away.

Did you notice the years on the ones you measured??.....reason I ask is that on the Mariners they upped the shaft size there from about 98 or so to the 2001 that I have....not sayin for sure but possible in the 355/356 model as well........ :popcorn:

km1125 · Post by **km1125** » March 13th, 2018, 9:55 am

You should send an email to Carver... I'm sure they'd know what they spec'd for the different engine combinations.

I looked in a parts manual for a 2002 356 and was surprised I didn't see the shafts or props mentioned anywhere. Thought I'd see a table of the various combinations based on engine options.

AnamCara · Post by **AnamCara** » March 13th, 2018, 9:13 pm

The 2 boats I looked at were a 1998 355 and a 2001 356. Both with 1.5 in shafts

tomschauer · Post by **tomschauer** » March 13th, 2018, 11:50 pm

I need new zincs this year, I better check my shafts before ordering. Everything I have says 1 3/8" but it sounds like that may be incorrect.
Thanks all.

jcoll · Post by **jcoll** » March 14th, 2018, 6:25 pm

My '98 355 with Crusader 454's has 1 1/2" dia. shafts.

Samuel · Post by **Samuel** » March 27th, 2018, 4:01 am

i am having work done its 1 1/2 inches. That is what you need in zinc size to.

tomschauer · Post by **tomschauer** » March 27th, 2018, 10:05 am

Yep, I confirmed last weekend that my shafts are indeed 1.5"

2000 356 propeller shaft size

2000 356 propeller shaft size

Re: 2000 356 propeller shaft size

Re: 2000 356 propeller shaft size

Re: 2000 356 propeller shaft size

Re: 2000 356 propeller shaft size

Re: 2000 356 propeller shaft size

Re: 2000 356 propeller shaft size

Re: 2000 356 propeller shaft size

Re: 2000 356 propeller shaft size

Re: 2000 356 propeller shaft size