Sherwood e35 pump bearing

[throwback2]

Qr Bbpost Throwback..what did you use for a bracket to secure the pump?

I ordered the brackets when I bought the pumps,can't remember what they look like.I will check the next time I get on the boat and get a picture.

[MakinTime]

Thanks for the input guys I will pull covers off and take a peak at the impellers. I got the starboard side pump on today so and pre made a bracket then take it to work and paint it. I’m glad I did my own brackets, it’s nice to be able to turn the pump for better hose routing.

[throwback2]

Here's a picture of the pump and bracket

[MakinTime]

Awesome thank you for the pic. I made some brackets today and they should work out good I will post pics after install. Thanks much.

[MakinTime]

Put the new pumps in this weekend got it all pretty much ready to go..ran out of hose clamps to double up on the pump side. Here are pics of my brackets and rubber mounting stud I put into the pump for mounting... worked out very well. Thanks all for your inputs.

[bud37]

Nice job...looks like it will work just fine........how was lining up the flange on the pulley ??....

[MakinTime]

On the pully there was 2 alignment holes that the pump fit into so it worked out well!

[throwback2]

Qr Bbpost Put the new pumps in this weekend got it all pretty much ready to go..ran out of hose clamps to double up on the pump side. Here are pics of my brackets and rubber mounting stud I put into the pump for mounting... worked out very well. Thanks all for your inputs.

Brackets look good,I think you will like those pumps too.