Spiral Stairs

1000islands · Post by **1000islands** » March 16th, 2014, 1:56 pm

I have been looking around for spiral stairs that go from the swim platform up to the aft deck on a 3607 without any success. So subsequently decided to have them made by a local metal fabricator at a cost of approximately $2400.

Then I was told about a company in Pennsylvania that will do them for under $1,000.

Has anybody ever heard of/know anything about, Salter Spiral Stairs?

DanM · Post by **DanM** » March 16th, 2014, 2:08 pm

Take a look at this link. It may be what you are looking for.
http://www.yachtforums.com/forums/carve ... cheap.html

eric_b · Post by **eric_b** » March 17th, 2014, 9:22 am

Here is an example of DIY stairs done to a 3207.

http://www.boatered.com/forum/topic.asp?TOPIC_ID=144725

1000islands · Post by **1000islands** » March 17th, 2014, 10:25 am

DanM wrote:Take a look at this link. It may be what you are looking for.
http://www.yachtforums.com/forums/carve ... cheap.html

Yes, that is exactly the stairs I am referring.

Cheryl · Post by **Cheryl** » May 3rd, 2014, 11:23 am

We just bought stairs for our 1989 36Carver Aft from Salter. The instructions are for installing in a house so we have to figure it out for the boat. At first glance it is looking alot like IKEA directions. First saw them here in a picture and that is why we ordered them. Hoping to find someone on the board that has done the installation already and can offer some tips before we attempt this.

1000islands · Post by **1000islands** » May 4th, 2014, 9:50 am

I am going to install mine this week, depending on the weather, so I'll let you know how it went.

Cheryl · Post by **Cheryl** » May 4th, 2014, 11:35 am

Weather permitting we are hoping to go to marina tomorrow. I will share info too.

Cheryl · Post by **Cheryl** » May 16th, 2014, 9:14 pm

The weather in our area hasn't been very co-operative to try to install stairs. Did you have any luck? Looking at the ladder that has to come it looks like we might have to cut it off, the Allen screws have probably never been touched since the boat was manufactured.

1000islands · Post by **1000islands** » May 25th, 2014, 10:07 pm

Staircase (1).JPG

Staircase (4).JPG

Staircase (2).JPG

Staircase (3).JPG

I had to cut the s/s to get the ladder off and I had to drill the screws out on the couplings that held it to the hull.....still looks crappy but it will be okay in the long run.

Cheryl · Post by **Cheryl** » May 27th, 2014, 8:47 pm

Where you have bolted it to the top of the boat, are you leaving the gap? Our step is 19" from the back of the boat to the first step. We are trying to come up with a solution to decrease that height.

Spiral Stairs

Spiral Stairs

Re: Siral Stairs

Re: Siral Stairs

Re: Siral Stairs

Re: Siral Stairs

Re: Spiral Stairs

Re: Spiral Stairs

Re: Spiral Stairs

Re: Spiral Stairs

Re: Spiral Stairs