Bilge Blowers

Anything related to the operation of your boat. Steering, Bilge Pumps, thru-hulls, bottom paint, etc.
Post Reply
User avatar
A Lee
Scurvy Dog
Scurvy Dog
Posts: 25
Joined: April 1st, 2018, 9:53 am
Vessel Info: 2005 56' Voyger
Location: Mississippi
Been thanked: 3 times

Bilge Blowers

Post by A Lee »

I have 4 Bilge blowers that are on separate breakers. With D12 engines, what is the recommended procedure for blowers? I have been told run them always, run them when at idle for extended period, run them after shut down to dissipate heat etc. Would like to hear advice/input.
Viper
CYO Supporter
CYO Supporter
Posts: 6266
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 475 times
Been thanked: 1791 times

Re: Bilge Blowers

Post by Viper »

Are you talking about the 3-4" exhaust blowers that should be turned on for 4-5 minutes prior to starting the engines, or the large flat circulation fans? Aside from turning on the exhaust blowers prior to starting, some folks keep them running for as long as the engines are. I don't see a down side except to say that it'll likely shorten the life of the blower unless its duty cycle is designed for that. If it's the large circulaion fans you're talking about, they're usually installed in diesel applications to maximize air flow to the engines, are typically controlled automatically when you turn the engines on, and are designed to run for hours (continuous duty). Some systems will also keep the fans running for a while after the engines are shut down.
User avatar
A Lee
Scurvy Dog
Scurvy Dog
Posts: 25
Joined: April 1st, 2018, 9:53 am
Vessel Info: 2005 56' Voyger
Location: Mississippi
Been thanked: 3 times

Re: Bilge Blowers

Post by A Lee »

I am referring to exhaust blowers. With gasoline engines, I understand the importance of running prior to start up. With diesels, I am getting feedback that is all over the place in terms of usage. I understand that some boat designs do not allow enough free air flow for the turbos. If that is not the case( which is not on 56 Voyger ) I assume the blowers are to reduce engine room temperature?
Viper
CYO Supporter
CYO Supporter
Posts: 6266
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 475 times
Been thanked: 1791 times

Re: Bilge Blowers

Post by Viper »

Yes any hot air you displace through either exhausting or circulation will be replaced with cooler outside air. The cooler denser air will maximize air/oxygen flow to the engines. While diesel applications aren't as explosive as gasoline, it's still desirable to be able to exhaust air from the bilge.
User avatar
bud37
Admiral
Admiral
Posts: 5184
Joined: April 23rd, 2015, 10:22 pm
Has thanked: 604 times
Been thanked: 1312 times

Re: Bilge Blowers

Post by bud37 »

An interesting consideration is how much fresh air a running engine brings in....at about 700 cu inches you would be pulling about 200 CFM at 1000 rpm per side......fun with numbers... :beergood:
FWIW.....The above is just my opinion.
User avatar
rjr
First Mate
First Mate
Posts: 120
Joined: May 17th, 2018, 9:36 pm
Vessel Info: 440 MY
Location: Lake St. Clair
Has thanked: 25 times
Been thanked: 9 times

Re: Bilge Blowers

Post by rjr »

It's the argument about diesels requiring vast amounts of air. Why remove air from the engine room? More air should be introduced into the engine room.
Viper
CYO Supporter
CYO Supporter
Posts: 6266
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 475 times
Been thanked: 1791 times

Re: Bilge Blowers

Post by Viper »

rjr wrote:Qr Bbpost It's the argument about diesels requiring vast amounts of air. Why remove air from the engine room? More air should be introduced into the engine room.

Technically you're not removing air, you're displacing it. You can't remove air from the compartment without it being replaced with air from outside otherwise you'd have a vacuum. Displacing the inside air with cooler outside air is what you want for the engines. You can do that by blowing in or exhausting out.
User avatar
denpooch
Commander
Commander
Posts: 386
Joined: April 9th, 2017, 8:03 pm
Vessel Info: 2005 360 Mariner
Crusader 6.0 Captains Choice
Location: Long Island
Has thanked: 85 times
Been thanked: 89 times

Re: Bilge Blowers

Post by denpooch »

My boat (gas) is designed to have the exhaust blowers running automatically whenever the engines are turned on.
Post Reply