Greetings,
While installing my stereo remote and snaking the wiring from salon stereo up to bridge I must have ripped off the wiring for my Dataline-X. I can't seem to figure out how to reattach the wires and get he thing working again. Also can't seem to locate where the previous owner would have installed the actual data box? Any ideas where on a 350 Mariner the data-box would be...attached pictures of the loose wires I located on the bridge but they don't seem to have a place. Any help would be much appreciated....
Rick
Simrad Dataline-x SDX wiring issue
-
RickieT
- Deck Hand
- Posts: 52
- Joined: June 17th, 2017, 5:33 pm
- Vessel Info: Carver 350 Mariner 1997
- Location: Sausalito, CA
- Has thanked: 18 times
- Been thanked: 3 times
- Contact:
Simrad Dataline-x SDX wiring issue
You do not have the required permissions to view the files attached to this post.
-
bud37
- Admiral
- Posts: 5182
- Joined: April 23rd, 2015, 10:22 pm
- Has thanked: 604 times
- Been thanked: 1312 times
Re: Simrad Dataline-x SDX wiring issue
Have you searched around under the dash, behind the front jump seat ?....... 
FWIW.....The above is just my opinion.
-
RickieT
- Deck Hand
- Posts: 52
- Joined: June 17th, 2017, 5:33 pm
- Vessel Info: Carver 350 Mariner 1997
- Location: Sausalito, CA
- Has thanked: 18 times
- Been thanked: 3 times
- Contact:
Re: Simrad Dataline-x SDX wiring issue
I found the rest of the cord tucked way up there....all set!!!
Sponsors