Carver 506 fuel leveling system between tanks

The is the forum to discuss general information regarding all Carver Yachts.
Post Reply
User avatar
jfloyd1010
Scurvy Dog
Scurvy Dog
Posts: 18
Joined: September 2nd, 2016, 4:55 pm
Vessel Info: 2001 Carver 506 "Endless Journey" 450 hp Cummins 6CTA 8.3-M engines
Location: New Bern, NC
Has thanked: 1 time
Been thanked: 3 times

Carver 506 fuel leveling system between tanks

Post by jfloyd1010 »

Hi - I have a fuel leveling valve system that is supposed to level the fuel between my starboard and port fuel tanks. The previous owner said he never got it to work properly. Does someone else have history with this option that can guide me to any tricks of the trade ? My generator pulls from the port fuel tank and is always considerably lower in fuel than the starboard tank.
Thanks,
Jim Floyd
Endless Journey
New Bern, NC
Viper
CYO Supporter
CYO Supporter
Posts: 6266
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 475 times
Been thanked: 1791 times

Re: Carver 506 fuel leveling system between tanks

Post by Viper »

You can do it a couple of different ways if you have the following options:
- Fuel selection/source valves allow you to select which tank either engine will draw fuel from. You can use this to direct both engines to draw fuel from the tank that has the most fuel, then return the valves back to the position that directs each engine to draw from it's own tank. These can be located in several locations; engine bay, aft cabin closet, under a step in the cabin or aft deck, etc. Always return the valves to a position that isolates the tanks from each other.
- Some applications have a fuel transfer pump that you can operate to transfer fuel from one tank to another. Look for a pump that has fuel lines going to each tank
User avatar
jfloyd1010
Scurvy Dog
Scurvy Dog
Posts: 18
Joined: September 2nd, 2016, 4:55 pm
Vessel Info: 2001 Carver 506 "Endless Journey" 450 hp Cummins 6CTA 8.3-M engines
Location: New Bern, NC
Has thanked: 1 time
Been thanked: 3 times

Re: Carver 506 fuel leveling system between tanks

Post by jfloyd1010 »

Thanks - I know I don't have a transfer pump, I'll just have to mess around with those valves.
I hope to get back to the boat in the next week or two. Just went through Hurricane Florence in New Bern, NC and no power to the entire city and marina...
User avatar
bud37
Admiral
Admiral
Posts: 5182
Joined: April 23rd, 2015, 10:22 pm
Has thanked: 604 times
Been thanked: 1312 times

Re: Carver 506 fuel leveling system between tanks

Post by bud37 »

Saw your location .......hope it turns around for the folk there......good luck to you...
FWIW.....The above is just my opinion.
Post Reply