Barrier Coatings are they it worth it?
- ColRon
- Admiral

- Posts: 581
- Joined: April 24th, 2017, 6:06 pm
- Vessel Info: 1989 Carver Santego 3867
“Escape Plan” - Location: Murray, KY
- Has thanked: 77 times
- Been thanked: 157 times
Re: Barrier Coatings are they it worth it?
Just a follow up on the work being done on Escape Plan.
er, you are correct, they are an Interlux shop, so they are using Epiglass for the blister repairs. Most of the ones in the photos are old repairs that had either failed or where close to failing, but this is what she was looking like last week after they had ground them out. And they are alternating the colors of the barrier coating to make sure of even coverage (White, Gray, White). Was just informed today that she should be ready either Tuesday or Wednesday of next week. Don't know if I will get the chance to drive up and get photos before they apply the bottom paint. But I feel much better after hearing from all you guys on the subject...and on a good note they had estimated 21 hours on the blister repair but only took 16, so it's not going to be as bad as initially thought. Even the Admiral has calmed down and is ready for it to be back in the water...She's ready for Boating season!
You do not have the required permissions to view the files attached to this post.
Ron
1989 Carver Santego 3867
“Escape Plan”
Murray, KY

1989 Carver Santego 3867
“Escape Plan”
Murray, KY
- Midnightsun
- CYO Supporter

- Posts: 2984
- Joined: March 27th, 2016, 2:27 pm
- Vessel Info: The Midnight Sun
2007 41CMY
Volvo D6-370's - Location: Montreal, Canada
- Has thanked: 272 times
- Been thanked: 1193 times
Re: Barrier Coatings are they it worth it?
Looks polka dotty.
Seriously, lots of hard work and a nice job, will be well worth the effort in the end. 
-
Viper
- CYO Supporter

- Posts: 6266
- Joined: July 10th, 2015, 9:58 pm
- Vessel Info: 1989 Carver 3807 Aft Cabin
- Location: Ontario, Canada
- Has thanked: 475 times
- Been thanked: 1791 times
Re: Barrier Coatings are they it worth it?
I'm assuming they'll remove ALL of the anti-fouling paint before filling in the blisters and applying a barrier coat?
- ColRon
- Admiral

- Posts: 581
- Joined: April 24th, 2017, 6:06 pm
- Vessel Info: 1989 Carver Santego 3867
“Escape Plan” - Location: Murray, KY
- Has thanked: 77 times
- Been thanked: 157 times
Re: Barrier Coatings are they it worth it?
Yes...I was informed at the beginning that they would remove all the old anti-fouling paint. That was a big part of the problem with the previous blister repair, they had been repaired over the old anti-fouling paint. The photos were taken last week while she was still drying out.
Ron
1989 Carver Santego 3867
“Escape Plan”
Murray, KY

1989 Carver Santego 3867
“Escape Plan”
Murray, KY
- ColRon
- Admiral

- Posts: 581
- Joined: April 24th, 2017, 6:06 pm
- Vessel Info: 1989 Carver Santego 3867
“Escape Plan” - Location: Murray, KY
- Has thanked: 77 times
- Been thanked: 157 times
Re: Barrier Coatings are they it worth it?
Well final update here. Blisters all repaired, final tally 102. Barrier coat installed (3 coats), new bottom paint (2 coats) and back in the water. Gained an additional 3 knots with the new bottom. Shop wants to pull and inspect her after two seasons for any new blisters.
You do not have the required permissions to view the files attached to this post.
Ron
1989 Carver Santego 3867
“Escape Plan”
Murray, KY

1989 Carver Santego 3867
“Escape Plan”
Murray, KY
- Cooler
- Admiral

- Posts: 1685
- Joined: May 22nd, 2018, 12:09 pm
- Vessel Info: 1995 Carver 330 Mariner
Twin 350XL Crusaders
Home port: Menominee, MI - Location: Green Bay, WI
- Has thanked: 68 times
- Been thanked: 414 times
Re: Barrier Coatings are they it worth it?
That looks good. Which formula did the yard use for the bottom paint? Getting additional speed is saving you money each hour you cruise, gaining 3 knots saves you 4 gallons each hour you run. Adds up pretty quick. You will be set for a few seasons. You did the right thing, and can rest assured with the hull.
er
Cooler By The Lake
( All weather people have to say this on air, near lakes )
( All weather people have to say this on air, near lakes )
- g36
- Admiral

- Posts: 2115
- Joined: April 7th, 2014, 6:07 pm
- Vessel Info: 1997 Carver 405
- Location: Soddy Daisy TN.
- Has thanked: 7 times
- Been thanked: 654 times
Re: Barrier Coatings are they it worth it?
Looks good sure you're ready for some boating now
1997 Carver 405
Crusader xli
The Black Pearl
Soddy Daisy Tn.
Crusader xli
The Black Pearl
Soddy Daisy Tn.
- RGrew176
- Admiral

- Posts: 6652
- Joined: August 17th, 2015, 4:07 am
- Vessel Info: 2023 SunTracker Party Barge 22 DLX
- Location: Southgate, MI.
- Has thanked: 72 times
- Been thanked: 470 times
Re: Barrier Coatings are they it worth it?
Looking good and the gain in top end is not a bad thing either. Hope you have a wonderful and fun season.
Rick Grew
2025 Godfrey Xperience 2286 SFLX
2004 Past Commodore
West River Yacht & Cruising Club
2025 Godfrey Xperience 2286 SFLX
2004 Past Commodore
West River Yacht & Cruising Club