Carver 406 AC /DC distribution panel removal

aloysius · Post by **aloysius** » September 25th, 2020, 7:32 pm

How do you get to the back of the AC / DC distribution panel that's located in the wall just aft of the dinette?

g36 · Post by **g36** » September 25th, 2020, 9:16 pm

Its very easy and its kind of hinged on the bottom not really a true hinge but if you'll Remove all screws around the panel except the 4 in the bottom middle. The ones on the outside bottom corners have to come out. Then it will tilt out from the top.

aloysius · Post by **aloysius** » September 26th, 2020, 2:45 pm

Wow. Thank you very much. Now I'm looking forward to trying it. My plan is to put a small light in the cabinet and also set up a 12v receptacle near the panel to access power to run / test various equipment used on the boat. Thanks again!

g36 · Post by **g36** » September 27th, 2020, 12:24 pm

You bet. Both the light and 12v power access will be handy

mjk1040 · Post by **mjk1040** » September 27th, 2020, 12:34 pm

Pictures of the project would be great!

Carver 406 AC /DC distribution panel removal

Carver 406 AC /DC distribution panel removal

Re: Carver 406 AC /DC distribution panel removal

Re: Carver 406 AC /DC distribution panel removal

Re: Carver 406 AC /DC distribution panel removal

Re: Carver 406 AC /DC distribution panel removal