New Member and longtime Carver owner
-
g36
- Admiral
- Posts: 2115
- Joined: April 7th, 2014, 6:07 pm
- Vessel Info: 1997 Carver 405
- Location: Soddy Daisy TN.
- Has thanked: 7 times
- Been thanked: 654 times
Re: New Member and longtime Carver owner
Welcome
1997 Carver 405
Crusader xli
The Black Pearl
Soddy Daisy Tn.
Crusader xli
The Black Pearl
Soddy Daisy Tn.
-
agoodstein@gmail.com
- Scurvy Dog
- Posts: 1
- Joined: July 14th, 2020, 7:46 pm
- Vessel Info: Carver 466 my
Re: New Member and longtime Carver owner
Hi Ron,
I also have a 466 MY (2004) and after doing tons or research, have found this to be the only affordable solution that does the Job. This unit will keep the Dinghy completely off the platform and drop's into the water freeing up additional space after the Dinghy is launch. I just literally ordered this, so can't tell you from experience, but I think this fits the bill. https://www.dinghydavits.com/shop/4ncx2 ... c8yakcdtci BTW the bottom of the lift is exactly 36 inches and I spoke to Carver who told me their are two heavy Alum plates exactly 36 inches off center from the platform edge 15 inches back. They are made for this type of application and you can drill and thread into them. They are 7 1/2 inches wide. Hope this helps.. Good luck
I also have a 466 MY (2004) and after doing tons or research, have found this to be the only affordable solution that does the Job. This unit will keep the Dinghy completely off the platform and drop's into the water freeing up additional space after the Dinghy is launch. I just literally ordered this, so can't tell you from experience, but I think this fits the bill. https://www.dinghydavits.com/shop/4ncx2 ... c8yakcdtci BTW the bottom of the lift is exactly 36 inches and I spoke to Carver who told me their are two heavy Alum plates exactly 36 inches off center from the platform edge 15 inches back. They are made for this type of application and you can drill and thread into them. They are 7 1/2 inches wide. Hope this helps.. Good luck
Sponsors