1750 RPMS

Anything related to the operation of your boat. Steering, Bilge Pumps, thru-hulls, bottom paint, etc.
Post Reply
User avatar
Michaemac
Scurvy Dog
Scurvy Dog
Posts: 3
Joined: April 25th, 2021, 6:48 pm
Vessel Info: 2005 Carver 56 Pilothouse
Location: Canada

1750 RPMS

Post by Michaemac »

Anyone have a solution as to why my boat won’t rev higher than 1750 rpms? I have 2005 56 Pilot house.
You do not have the required permissions to view the files attached to this post.
User avatar
km1125
Admiral
Admiral
Posts: 3658
Joined: February 28th, 2017, 6:04 pm
Has thanked: 81 times
Been thanked: 1114 times

Re: 1750 RPMS

Post by km1125 »

I don't know that system at all, but it seems like Error 55 on a CruiseCommand comes back to a battery issue.

Is this just one engine or both?
User avatar
Michaemac
Scurvy Dog
Scurvy Dog
Posts: 3
Joined: April 25th, 2021, 6:48 pm
Vessel Info: 2005 Carver 56 Pilothouse
Location: Canada

Re: 1750 RPMS

Post by Michaemac »

It’s on both engines. Not sure if that’s the issue. I will power them off and back on and see if that’s the issue. When I run her at 1750 it shows 100% load on the engines?
Viper
CYO Supporter
CYO Supporter
Posts: 6267
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 475 times
Been thanked: 1791 times

Re: 1750 RPMS

Post by Viper »

Did you check the basics first; clean air filters, clean fuel filter assemblies, new fuel filters? Do they smoke a lot? Does the boat get used a lot, how old is the fuel?

It would help to know what engine package we're talking about here.
User avatar
buster53
Admiral
Admiral
Posts: 1170
Joined: May 12th, 2017, 10:41 am
Vessel Info: 2001, Carver 356
Location: Gwynn’s Island, VA
Has thanked: 10 times
Been thanked: 285 times

Re: 1750 RPMS

Post by buster53 »

When was the last time the bottom and running gear was cleaned?
User avatar
Michaemac
Scurvy Dog
Scurvy Dog
Posts: 3
Joined: April 25th, 2021, 6:48 pm
Vessel Info: 2005 Carver 56 Pilothouse
Location: Canada

Re: 1750 RPMS

Post by Michaemac »

All the maintenance has been done on the. Cummings engines. J believe they’re 660’s. It just happened for the first time last week.
I’m thinking of restring the cruise commander. I also have trolling valves installed in vancouver for fishing. I got some wired going on.
User avatar
km1125
Admiral
Admiral
Posts: 3658
Joined: February 28th, 2017, 6:04 pm
Has thanked: 81 times
Been thanked: 1114 times

Re: 1750 RPMS

Post by km1125 »

Is it possible it's in trolling mode? Again, don't know that system but just doing some quick reading it seems like you can toggle it into a "trolling mode" which restricts the engines so they only will go to part throttle.
Viper
CYO Supporter
CYO Supporter
Posts: 6267
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 475 times
Been thanked: 1791 times

Re: 1750 RPMS

Post by Viper »

Some applications also have a switchable low rpm setting for docking, etc.
Post Reply