Hi everyone,
I'm slowly learning where everything is located on my Carver. My steering is operational in the lower helm, but not working in the upper helm. It was suggested that the system may not need fluid, but may need to be pressurized to 15-20 PSI. Does anyone know where the hydraulic steering pump is located?
Much appreciated,
John
Location of hydraulic steering pump on 1986 Carver 42 Aft Cabin
- curran_286@msn.com
- Scurvy Dog

- Posts: 3
- Joined: October 16th, 2021, 2:12 pm
- Vessel Info: 1986 Carver 42 Aft cabin motoryacht
- Location: Mashpee
- Has thanked: 4 times
-
Viper
- CYO Supporter

- Posts: 6266
- Joined: July 10th, 2015, 9:58 pm
- Vessel Info: 1989 Carver 3807 Aft Cabin
- Location: Ontario, Canada
- Has thanked: 475 times
- Been thanked: 1791 times
Re: Location of hydraulic steering pump on 1986 Carver 42 Aft Cabin
The pump or helm is what the steering wheel is fastened to. I assume you are asking for the location of the oil reservoir/pressure tank. It can anywhere along the hydraulic line routing but it should be in an accessible spot. If you don't see it under the helm or in the engine compartment, check in the aft cabin at the transom, there should be access to the steering cylinder, rudders, trim tab pump, etc. You're looking for something like this, check the fluid level and pressure as indicated on the label....
You do not have the required permissions to view the files attached to this post.
- denders
- Deck Hand

- Posts: 78
- Joined: August 24th, 2015, 6:21 pm
- Vessel Info: 1985 Carver 3607 Aft Cabin
- Has thanked: 2 times
- Been thanked: 24 times
Re: Location of hydraulic steering pump on 1986 Carver 42 Aft Cabin
On our 85 3607 the reservoir is under the bed in the aft cabin on the starboard side. We keep a bicycle pump on board just in case it needs to be pressurized.
- km1125
- Admiral

- Posts: 3657
- Joined: February 28th, 2017, 6:04 pm
- Has thanked: 81 times
- Been thanked: 1114 times
Re: Location of hydraulic steering pump on 1986 Carver 42 Aft Cabin
Here is another example of what you would be looking for. Not sure when they stopped using this one, but it's an older one.
You do not have the required permissions to view the files attached to this post.
- waybomb
- CYO Moderator

- Posts: 2745
- Joined: February 5th, 2013, 9:24 pm
- Vessel Info: 1995 Boston Whaler Rage15
1987 3697 Carver Mariner
1988 Cougar 46 Kevlar Vee offshore
1969 15' Glasspar / 1967 Johnson Electromatic 85 - Location: Saint Joseph,Mi
- Has thanked: 69 times
- Been thanked: 492 times
Re: Location of hydraulic steering pump on 1986 Carver 42 Aft Cabin
In had a 4207, but no exactly sure of the location anymore. It may be at the transom.
You may have access through the port side "night table" next to the bed. There is a removable panel in the lower section.
If not, you may have to remove the mattress, then the cover, then another cover under that storage compartment.
If that's where it is, I suggest you climb into the storage space under the bed before heading to the bilge with your arms. I did- not do this and went in from the bed platform. I got in alright, and then slipped in a bit farther, and could not get out. My wife was visiting a neighbor's boat. And there I am beating in the hull and screaming "Help!" Finally she hears it, comes down to the aft room, sees my legs sticking out of the hole in the bed platform, and of course, begins to laugh. Avoid that! But have somebody nearby in case you can't get out.
You may have access through the port side "night table" next to the bed. There is a removable panel in the lower section.
If not, you may have to remove the mattress, then the cover, then another cover under that storage compartment.
If that's where it is, I suggest you climb into the storage space under the bed before heading to the bilge with your arms. I did- not do this and went in from the bed platform. I got in alright, and then slipped in a bit farther, and could not get out. My wife was visiting a neighbor's boat. And there I am beating in the hull and screaming "Help!" Finally she hears it, comes down to the aft room, sees my legs sticking out of the hole in the bed platform, and of course, begins to laugh. Avoid that! But have somebody nearby in case you can't get out.
Thanks
Fred
1969 Glaspar Avalon /1967 Johnson Electromatic 85
1987 Carver Mariner
1988 Cougar Kevlar 46' with triple blown 572 ci
1995 Boston Whaler Rage
Past - 1988 2807, 1989 4207 Aft
Fred
1969 Glaspar Avalon /1967 Johnson Electromatic 85
1987 Carver Mariner
1988 Cougar Kevlar 46' with triple blown 572 ci
1995 Boston Whaler Rage
Past - 1988 2807, 1989 4207 Aft
- bud37
- Admiral

- Posts: 5182
- Joined: April 23rd, 2015, 10:22 pm
- Has thanked: 604 times
- Been thanked: 1312 times
Re: Location of hydraulic steering pump on 1986 Carver 42 Aft Cabin
Did she take any pics of this you can post.........
FWIW.....The above is just my opinion.
- waybomb
- CYO Moderator

- Posts: 2745
- Joined: February 5th, 2013, 9:24 pm
- Vessel Info: 1995 Boston Whaler Rage15
1987 3697 Carver Mariner
1988 Cougar 46 Kevlar Vee offshore
1969 15' Glasspar / 1967 Johnson Electromatic 85 - Location: Saint Joseph,Mi
- Has thanked: 69 times
- Been thanked: 492 times
Re: Location of hydraulic steering pump on 1986 Carver 42 Aft Cabin
Too bad she didn't. It would be framed and displayed prominently.
Thanks
Fred
1969 Glaspar Avalon /1967 Johnson Electromatic 85
1987 Carver Mariner
1988 Cougar Kevlar 46' with triple blown 572 ci
1995 Boston Whaler Rage
Past - 1988 2807, 1989 4207 Aft
Fred
1969 Glaspar Avalon /1967 Johnson Electromatic 85
1987 Carver Mariner
1988 Cougar Kevlar 46' with triple blown 572 ci
1995 Boston Whaler Rage
Past - 1988 2807, 1989 4207 Aft