Forward bilge. Pump
-
Rpratto
- Scurvy Dog
- Posts: 2
- Joined: December 8th, 2015, 7:49 pm
- Vessel Info: 1986 carver Santa Cruze
- Location: Spring hill fl
- Has thanked: 3 times
- Been thanked: 1 time
Forward bilge. Pump
Have a 1986 Carver Santa Fe and can not figure out where the front bilge pump goes to ran a 20 foot snake through it and could not find out where it goes. No hoses run out through the hull fitting called carver and they do not know either think it runs water from front bilge to engine compartment bilge. Oh well
-
SHEMP
- Deck Hand
- Posts: 51
- Joined: March 7th, 2013, 7:43 pm
- Vessel Info: 2000 CARVER 456 MY
Full Bridge and aft deck enclosure
Originally purchased in Staten Island
Second owner also purchased in Staten Island in 2012
Now berthed in Toronto Canada
A wonderful and fully appointed luxury yacht. - Location: Toronto Ontario Canada
- Has thanked: 7 times
- Been thanked: 4 times
Forward bilge. Pump
Heres what I would do, put food coloring in the bilge water near your front pump, turn on the pump and look around for the colored water.
-
Ramsport47
- Commander
- Posts: 376
- Joined: February 10th, 2013, 7:13 am
- Vessel Info: 1998 Carver 310 Santego
- Has thanked: 72 times
- Been thanked: 59 times
Forward bilge. Pump
If it is factory installed, it will not run back to the engine compartment...Carver never did something so "backyard". It has to go out the side a short distance from the pump. My guess would be on the same side as the galley sink, or possibly, the other side in the same area. I assume you have a 2667 Santa Cruz
Kenny
1998 Carver 310 Santego
T-Merc 350 Mag MPI (300hp)
Port: Cedar Point Marina, Sandusky, Ohio
1998 Carver 310 Santego
T-Merc 350 Mag MPI (300hp)
Port: Cedar Point Marina, Sandusky, Ohio
Sponsors