Holding tank Level sender part number
-
Barnaclebill
- Scurvy Dog
- Posts: 8
- Joined: February 5th, 2017, 12:54 pm
- Vessel Info: Lindy Star
2004 Carver 360 Mariner
Volvo 5.7 Liter GXI Gas Engines - Location: Southport, North Carolina
- Has thanked: 1 time
Holding tank Level sender part number
I need the part number for the holding tank level sender. My mechanic ordered one and got a three wire plug. Mine has a four wire plug. The boat is a 2004 36 Mariner with a 20 gallon tank, later Mariners had a larger tank but the same height so I thin the sender is the same. Any helpwould be appreciated.
Barnacle Bill
Lindy Star
2004 Carver 360 Mariner
Twin Volvo 5.7L GXII-F
Southport, NC
Lindy Star
2004 Carver 360 Mariner
Twin Volvo 5.7L GXII-F
Southport, NC
-
Bentone23
- Deck Hand
- Posts: 57
- Joined: April 10th, 2018, 10:58 pm
- Vessel Info: 1996 Carver 355 Aft Cabin
454 xli TBI Crusaders - Location: San Francisco Bay
- Has thanked: 57 times
- Been thanked: 5 times
Re: Holding tank Level sender part number
I have a Tankwatch III in my ‘96 355. Three tubes and 3 lights checks at 3 levels. You probably have a Tankwatch IIII which has 4 tubes.
Bruce Bennett
Bentone23@sbcglobal.net
1996 355 Aft Cabin
Central California
Boating on the Delta and SF Bay
Bentone23@sbcglobal.net
1996 355 Aft Cabin
Central California
Boating on the Delta and SF Bay
-
pepmyster
- Admiral
- Posts: 1035
- Joined: June 5th, 2018, 7:17 am
- Vessel Info: 2004 Carver 360 Sport Sedan
8.1 Volvo Penta
Fresh water boating - Location: Ottawa
- Has thanked: 492 times
- Been thanked: 211 times
Re: Holding tank Level sender part number
We just replaced ours, with a Tank watch exterior sensors. Never again am I going to remove that sensor to clean!
Sponsors