Based in London, England we don't have much access to many spares or new old stock for our boat.
However, we did mange to get some new Side Vents from searayman13 http://www.ebay.co.uk/itm/BOAT-VENT-7-L ... VFicqbased in Massapequa, New York.
Anyone 'across the pond' know if we can still obtain curtains 'off the shelf' so to speak ?
Thanks & regards,
Phil
Carver 32 (3207) 1990 - Curtains
-
Lagniappe
- Scurvy Dog
- Posts: 2
- Joined: September 19th, 2013, 7:54 am
- Vessel Info: 1990 Carver 32 Aft, Twin Volvo Penta TAMD41B 200HP Diesels
- Location: River Thames, London England
-
Ramsport47
- Commander
- Posts: 376
- Joined: February 10th, 2013, 7:13 am
- Vessel Info: 1998 Carver 310 Santego
- Has thanked: 72 times
- Been thanked: 59 times
Re: Carver 32 (3207) 1990 - Curtains
Unfortunately, I don't think you'd be able to get these any longer. I think Carver keeps patterns active for about 7 years after a model ends production (which was 1990 for your boat). The best thing would be to have a local shop make them, or try it yourself. My partner made new curtains for our boat...his first attempt...and they turned out great!
Kenny
1998 Carver 310 Santego
T-Merc 350 Mag MPI (300hp)
Port: Cedar Point Marina, Sandusky, Ohio
1998 Carver 310 Santego
T-Merc 350 Mag MPI (300hp)
Port: Cedar Point Marina, Sandusky, Ohio
-
Viper
- CYO Supporter
- Posts: 6266
- Joined: July 10th, 2015, 9:58 pm
- Vessel Info: 1989 Carver 3807 Aft Cabin
- Location: Ontario, Canada
- Has thanked: 475 times
- Been thanked: 1791 times
Re: Carver 32 (3207) 1990 - Curtains
Welcome aboard Phil.
What Kenny said. You can also give Carver a call but I doubt they'll have any in stock. If this is something they contracted out to a third party, they would give you the contact info you need and part numbers based on your hull number so have your hull number handy when you call. Chances are the third party manufacturer will still have patterns on file. This however while original equipment, usually tends to be pricey. I'd look locally for a seamstress that will come out, take some measurements and make them for you if it's is something you can't handle yourself.
Keep us posted and pictures are always popular here!
What Kenny said. You can also give Carver a call but I doubt they'll have any in stock. If this is something they contracted out to a third party, they would give you the contact info you need and part numbers based on your hull number so have your hull number handy when you call. Chances are the third party manufacturer will still have patterns on file. This however while original equipment, usually tends to be pricey. I'd look locally for a seamstress that will come out, take some measurements and make them for you if it's is something you can't handle yourself.
Keep us posted and pictures are always popular here!
Sponsors