1998 355 AC/MY Wet Bar Cabinet R&R for re-sealing

[mjk1040]

Ok has anyone unscrewed the wet bar from the deck floor so they can re-seal it and the screws? There's a subfloor under the ice maker with 3 screws on the right side holding it down if your facing the cabinet, but this panel appears to go under the left side doored cabinet. I want to re-seal all the cabinet mounting screws that hold the cabinet down to the deck, I can see 3 or 4 in the back of the cabinet since the sub floor is notched out and I assume there are more mounting screws in the front of the cabinet, but don't know if this sub floor panel will come out after just removing the three screws on the right side.
Mike

[mjk1040]

Well 85 of you have read this post but no one has done this I guess? Guess I'll find out by trial and error, got to install the new Edgestar ice maker and really want to reseal this cabinet before I do. MJK

[AaHubb]

Can you take some pics and post them? Might help someone in the future.

[tomschauer]

I recently purchased a 1998 355. I have started at the bow and am working on rebidding everything. I am about four weeks away from the wet bar. If you get to it before me, please let us know what you learned. If I beat you to it I will do the same.

Tom

[mjk1040]

Ok guys will do. Mike

[mjk1040]

Well I pulled the screws that are visible when the ice maker is removed. The sub floor did not come out, it appears you may have to dis assemble the entire interior of the cabinet to get a clear view of the cabinet base. resealed all the screws I could get at and installed our new Edgestar ice maker. FYI, a little trimming and it fits right in and you save big bucks compared to buying a new Icerette ice maker. Mike