Found this while thinking of ways to improve my cooking situation on the boat. I had been very seriously considering putting in a newer electric stove until someone here pointed out the amperage. Since then I have been strongly considering installing a propane set-up, and still am, but this link does give food for thought.
https://mvsoundtrek.blogspot.com/2019/05/renewing-old-princess-stove.html
If it weren't for the fact that my oven coil connections are rusted out on my Princess, I would really be thinking of installing this Mini Duo to refresh the galley with minimum cost.
Princess Stove Renew
- vineyardgray
- Captain

- Posts: 262
- Joined: July 15th, 2018, 10:26 pm
- Has thanked: 128 times
- Been thanked: 33 times
- Contact:
- Midnightsun
- CYO Supporter

- Posts: 2984
- Joined: March 27th, 2016, 2:27 pm
- Vessel Info: The Midnight Sun
2007 41CMY
Volvo D6-370's - Location: Montreal, Canada
- Has thanked: 272 times
- Been thanked: 1193 times
Re: Princess Stove Renew
I made the conversion to convection on my previous boat probably about 15 years ago and never looked back. One of the first things I did to the Carver when I got her. Really works well and cooks so much quicker on the limited 110v most of us have on board not to mention the precise temp control. Boiling water on one of these is as fast as a butane stove. It does require shore power/generator but without all the complexities of gas. We renovated our kitchen at home a few years ago, went to induction from gas, love it.
This article came up recently on the news, interesting to say the least. https://www.cbc.ca/news/science/gas-sto ... -1.6394514

This article came up recently on the news, interesting to say the least. https://www.cbc.ca/news/science/gas-sto ... -1.6394514

- bud37
- Admiral

- Posts: 5182
- Joined: April 23rd, 2015, 10:22 pm
- Has thanked: 604 times
- Been thanked: 1312 times
Re: Princess Stove Renew
vineyardgray wrote:Qr Bbpost Since then I have been strongly considering installing a propane set-up, and still am, but this link does give food for thought.
Personally I like the induction idea, having had experience with propane I would strongly caution its use on a boat because the gas is more dense than air and a leak will settle in low places and is extremely hard to vent correctly on a boat. Also too much vibration for joints and lines, just a bad idea in my considered opinion.
Sure there are boats with set ups, there will always be, but that does not change the facts of the gas itself and the correct install has many hoops to jump thru regulation wise........good luck with your refit..
FWIW.....The above is just my opinion.
- Grafunkus
- Captain

- Posts: 203
- Joined: September 2nd, 2015, 5:22 pm
- Vessel Info: 1982 33' Carver Mariner
1985 3607 Carver Aft Cabin - Location: Manitoba, Canada
- Has thanked: 63 times
- Been thanked: 32 times
Re: Princess Stove Renew
What a beautiful conversion.
Our first Carver had propane and it worked very well. Our current boat has the electric three burner stove top. Hate it. We are currently using a portable butane camp stove. The previous owner had left an older induction burner but we never did figure out how to use it and couldn't find an owner's manual on line.
Our first Carver had propane and it worked very well. Our current boat has the electric three burner stove top. Hate it. We are currently using a portable butane camp stove. The previous owner had left an older induction burner but we never did figure out how to use it and couldn't find an owner's manual on line.