So we went to check in the boat today and do some odds and ends. I found the engine compartment had some water around the bilge pump. It’s not pumping in auto. I did find a broken wire laying in the water, but I don’t see a float switch. It’s an Attwood 1500 gph. Not sure why it’s not pumping in auto and not sure where the water is coming from. Both shafts drip a drop about every ten seconds from the packing. Is that normal? Should the bilge be dry? I’d say it was about 2 to 3 gallons over two weeks. I guess I have two questions, 1 bilge pump set up on an 88’ 3807 and 2 is the water issue even an issue?