I have a Carver 42 SS 2007 that needs a new side window. Does anyone know what colour tint the replacement glass should be to match the original?

On a Carver 466, over time some of the window seals flex and pull out and leak. Has anyone found a good (non messy) way to reseal and tuck the black curved bead back in?

Need an Ac electrical diagram for pumps under galley floor for a 4207, 1988. Need to identify main power source for the three Ac pumps. Wiring had minor change which prevents me from running Ac fans or pumps while on shore power but fans run when on generator but not pumps. I have the carver manual but it does not elaborate on this area.

I seem to be going through batteries fairly quickly. Maybe 2 years out of AGM 8Ds. I have 2 separate 8D starting batteries and an 8D house battery. I just happened to touch my House battery yesterday and it was pretty hot. So I unwired both of the negative leads and let it sit. It cooled down. Then I put one of the 2 leads back on the negative and could operate most of my 12v systems. I'm thinking the other lead runs to the Vanner IQC12 inverter, because the leds are out on the remote pan ...

I have a 560 voyager that the port head vent fan quit, I can see it through a hole in the forward v-birth closet. But I can not reach it to remove.Anybody ever replaced it or know how.
Thanks

Hello.
I have recently purchased a Carver 36 1989 that had some deck delamination. I have repaired the problem areas but am having a little problem matching the deck color. I would like to use Interlux Bright Side paint. Any suggestions which colour is the closest match?
Gordon

The aerators on my boat are a bit beat up from previous owner removing with what looks like pliers.
I can't seem to find any that are the right size (5/8") diameter instead of the standard 15/16".
Any ideas?
Or do I have to get an adapter and then use the 15/16.

Boat: 2009 44 Sojourn

I want to throw out a warning about ordering replacement LED recessed lights concerning the hole cutout diameter. The carvers seem to be quite accurate at 2" hole size. I ordered these ALOVECO LED RV Lights, 12V Led Lights Dimmable Camper Interior Lights 3000K Ultra-Thin RV Lights Interior Waterproof 12 Volt LED Ceiling Lights Motorhome Sailboat Yacht Case of 8 Packs I want to throw out a warning about ordering replacement LED recessed lights concerning the hole cutout diameter. The carvers seem to be quite accurate at 2" hole size. I ordered these ALOVECO LED RV Lights, 12V Led Lights Dimmable Camper Interior Lights 3000K Ultra-Thin RV Lights Interior Waterproof 12 Volt LED Ceiling Lights Motorhome Sailboat Yacht Case of 8 Packs ...

Did a lot of research and see that the Dexron II fluid is yellow or light brown, so I was confused abouit it being gear lube. What has replaced this for my Hurth filter and fluid change? I see that Dexron VI is backwards compatible for Dex II?

Hey All,
I"ve had issues with my Port engine on my 1999 Carver 350 and have narrowed it down to a bad fuel pump. After identifying the part #, I've learned the pump is not sold separately anymore, but is now sold as a "fuel pump cooling kit" (861156A02). Has anyone out there experienced this and/or had to replace their electric fuel pump and have suggestions for an online vendor?

Thanks
Steve (Batwing)