My horns on my 1994 390 are tired, so much they sound like a turtle crossing the road. I found them up front under the forward cubby. They are strange looking as they are down turned to the bottom cut out . I am going to see if i can get a pic. Anyone else know what I mean or replaced their horns?

Purchased a new to us 1988 3227 Convertible that was not equipped with a windlass. A friend gifted me a Lofrans X2 he had as a spare, but I'm not sure where to install given small rode locker and limited deck space.

Has anyone installed a windlass on this year/model?

With appreciation,
Trev

Hello - Can anyone tell me what size the optional 3rd fuel tank is on a 2003 Carver 356?

Best,
Eric

'83 3607 aft cabin "Damn Boat". Neither pump is getting power, but I have power to the switches. Since the bilge sniffer doesn't work either, I suspect my problem lies in the cabling from the lower helm to the units. Doe anyone happen to know how the cable is routed from the lower helm? I just don't want to disassemble more than I have to to check the connectors.

Any and all help is greatly appreciated.

An Old Goat
With An
Old Boat

Good day,

I recently bought a used 1983 Riv. The previous owner swapped out the Crusaders back in 2003 with GM 4-bolt mains truck 350 cid engines.

Can anyone share their opinion about these? Does anyone have documentation about them?

Thank you!

We just bought our '88 Carver 3607 and after the hot water tank heats up, the smell is awful like raw onions marinating in sewer. Ran three bottles of odour/sanitizer through it and now fresh water is good and hot water is good as long as its cold. Any ideas?

On my Carver 28 (1988), 2 x 5.7L 350 Crusaders i want to replace the packing or the stuffing boxe's.

After winter when i put the boat in the water the stuffing boxe's leak as fu*k but after i start the engines and put in gear it just droppes like a drop every 5 seconds and in the end of the season it has stopped leaking. But this year one of the prop shafts leaked alot after that and i bought some tools to be able to tighten the packing nut and got the leak to almost stop. But i am lucky this was ...

Hi - Anyone know the model # for a replacement Aircon strainer basket for 19 C36 - and a source, maybe link, to buy online. Thanks for your help!

My fridge in our 390CPMY is an original NORCOLD. It is working but I believe it is getting old and I am not one who likes to replace when “under the gun” so to speak, so I am thinking of a planned replacement. I have seen Norcold, Isotherm and Vertrigo. Any input? I have a two door type freezer on top approx 7 to 8 cu ft.

Hi. If anyone can tell me what this three beep alarm means. I will explain circumstances.

I have a 396MY - 2001. My engines were starting perfecting until approximately a week and a half ago, when my port engine decided not to start. I have the push button run/start/stop keypad for my engines. Normally you will get a loud beep, which sets the engines ready to start. I receive that on my starboard side motor, but not on the port engine. Let me explain just a little further. I was able to st ...