My Malber dryer stopped heating and my repair guy can’t find the replacement heat element because as we all know Malber no longer exist.

Any ideas on where to get the part or recommendations on replacement unit? Maybe it’s time to replace the washer and dryer…they are 23 years old!

Thanks for any help…obviously they need to fit in the same space etc.

I am looking to find what series the portlight are on my boat. I am looking to replace the and any help would be graetly appreciated.

Hi all new member here.. i have a 1999 Carver 530 and the port engine has overheated and Cummins has stated it has to be removed to be rebuilt.... so how is this achieved.. does the galley have to be removed... has anyone on here attempted this.. any help would be greatly appreciated ...Regards Paul

I will be removing the bimini and frame with the complete set of isenglass panels in late September. I am installing a new hardtop in place of the bimini. The framing is in excellent condition and the bimini top is original with no rips or tears, leaks in a few spots and needs to be treated again. The isenglass front panels in excellent shape, one side panel new and other side has small crack. All zippers are good. The aft deck isenglass panels are in great shape and available too.

If interested ...

My wife and I are new the Carver Yacht life. Everything is big and overwhelming. We have had our 2002 356 for about a month with very little big boat experience. That being said we worry a lot. Most of our worry I feel is not knowing what switch to flip when, what is to stay on, or pump this and fill this here, etc. My latest worry yesterday is the forward bilge would come on every 5 minutes like clockwork. It has never run before but continued to to pump yesterday. I turned the dock water hydra ...

We just bought our new to us C37 - had 38 hours on her, great shape. She has a black roof, grey hull. Looks like a Batmobile Boat!

The day we took possession, some dock mates of the previous owner told us that Carver had come out to repaint the top just 2 months earlier. At Carvers expense. We didn't think too much of it, though it was not disclosed by the previous owner. Everything passed inspection.



It is now 2 months later and the top part of our hull is chipping, cracking, oxidiz ...

Hello Everyone,



Does anyone own a 92 carver 33’ aft cabin with twin Tamd41b diesels and If so what is the speed at WOT and cruise?



I think I may have the wrong pitch props, it wont get up on plane .

3800rpm WOT @ 15mph and 3100rpm cruise @ 11mph

Burning approximately 1 gallon per mile total for both engines @ 3100rpm

All tanks empty except 220 gallons of fuel. All canvas removed to lessen wind resistance

Typical Volvo smoke on start up (very light fuel smoke) and smokes light black when ran WOT

Engines ...

I recently purchased a 1994 voyager. There is a pre-existing speaker system without a radio installed on my Boat. My question is where is the origin point for installing the radio. I am unable to track where all the feeders and audio feed are emanating from. I have searched for wiring diagrams of the system and have not found anything useful. Thank you

Hi Guys,



My 28 Riv has a hot water tank that can be heated with shore power or by one of the water cooled engines - through the heat exchanger. We think there is a break in the heat exchanger and that water is escaping.



Here is our plan, but I need some help.



1. We plan on disconnecting the hoses from the engine at the hot water tank heat exchanger connections.

2. We will install 2 valves on the connections on the hot water tank for the heat exchanger (this will close things off).



Question. Can ...

Well, I came to the boat last night to find that the A/C in the stateroom would not work . Spent the morning troubleshooting it an it appears that the compressor has locked up. It’s a 12,000 btu unit from Marine Air and it’s original to the boat, so it’s given 30+ years of service. The salon unit was replaced a few years ago with a new Dometic (Cruisair) 16,000 btu and has never struggled to cool it portion of the boat. I have spent the most of the day shopping for a new ...