Greetings all. Due to take possession of our 2006 36 Mariner next week. We're going from a 32' express cruiser, which has been a great boat for us, to the 36 Mariner. Carvers all over our dock and our lake and I have always been envious. We're excited to move up and can't wait to get boating. BTW, Table Rock Lake near Branson Missouri.

Ive had my 1985 3607 with twin motors for two years and trying to figure out my gas consumption. I figure im going through about a gallon per mile at a average 8 to 10 knots. Can anybody tell me if this is close to factory specs . Thanks brent

Looking to replace all the port holes in my 1985 Carver 3607 aft cabin. Does anybody have any good sites or companies that would sell these. well appreciated Brent

I have just bought a new FF chart plotter combo for my 404. Does anyone know the best way to run the cable from the engine room to the helm? There must be a duct or conduit for such a run. Thanks,

I have a carver 404, the swim platform is getting a little spongy. I assume I have some water ingress and it needs to be recored. What is involved and how much should it cost? WHat is the best way to do it? Are replacement platforms available? Thanks,

My wife and I just picked up our first Carver. 1989 32 Montego, and absolute beauty. We are looking forward to many adventures with her in the San Juans in the coming years.

I recently purchased a 2003 366. I am wanting to have an extended swim platform installed. Boat is on a freshwater lake in the Midwest. I also want to install underwater lighting. Can anybody steer me in the right direction on the platform. So far I have been searching the Internet. I don't know if these are premade or if I will have to have one custome made. Any ideas???

I am interested in having a bow thruster installed on my Carver 4207. Has anyone got any experience on such project ? thanks in advance !