1988 Carver 3067 Santego trimming outdrives
-
Mowery1
- Scurvy Dog
- Posts: 4
- Joined: July 19th, 2017, 9:48 pm
- Vessel Info: 1995 Carver 280 express
- Location: Indiana
- Has thanked: 1 time
Re: 1988 Carver 3067 Santego trimming outdrives
The boat is in the shop right now getting the starboard outdrive replaced. Impellers replaced in both drives along with gimbals and changing the fluids..Ill check everything out before it goes back into the water..
-
bud37
- Admiral
- Posts: 5182
- Joined: April 23rd, 2015, 10:22 pm
- Has thanked: 604 times
- Been thanked: 1312 times
Re: 1988 Carver 3067 Santego trimming outdrives
Hopefully they may pick up on something while they are working on the drives.....I wouldn't assume anything while working thru a problem....cross things off the list one at a time.
FWIW.....The above is just my opinion.
-
Viper
- CYO Supporter
- Posts: 6266
- Joined: July 10th, 2015, 9:58 pm
- Vessel Info: 1989 Carver 3807 Aft Cabin
- Location: Ontario, Canada
- Has thanked: 475 times
- Been thanked: 1791 times
Re: 1988 Carver 3067 Santego trimming outdrives
I assume they are reinstalling the drives? If so, do they know about the trim issue? If not, tell them so they can check the trim limit switch adjustment in case that's the problem. If the limit switches have to be replaced, I find it easier to do without the drives in the way.
-
theorifice
- Scurvy Dog
- Posts: 41
- Joined: July 31st, 2022, 1:28 pm
- Vessel Info: 1987 Carver Santego 30
- Location: Chicago
- Has thanked: 16 times
- Been thanked: 4 times
Re: 1988 Carver 3067 Santego trimming outdrives
Did you ever get this figured out? I think I have the same problem where the motors are trimmed all the way up but now responding to down trim
Fun times on the 1988 Carver Santego 30
Sponsors