2004 Carver 360 Mariner

Anything related to the operation of your boat. Steering, Bilge Pumps, thru-hulls, bottom paint, etc.
Post Reply
User avatar
GlenburnieBoater
Scurvy Dog
Scurvy Dog
Posts: 4
Joined: May 1st, 2021, 10:57 pm
Vessel Info: 2004 360 Mariner
Location: Maryland
Has thanked: 3 times

2004 Carver 360 Mariner

Post by GlenburnieBoater »

Asking for a friend: new to this model 2004 360 Mariner and need to know HOW TO LOCATE AND ACCESS THE WATER HEATER. please advise!
User avatar
bud37
Admiral
Admiral
Posts: 5184
Joined: April 23rd, 2015, 10:22 pm
Has thanked: 604 times
Been thanked: 1312 times

Re: 2004 Carver 360 Mariner

Post by bud37 »

Not completely sure on the newer model but have a look under the dinette seats......
FWIW.....The above is just my opinion.
Viper
CYO Supporter
CYO Supporter
Posts: 6267
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 475 times
Been thanked: 1791 times

Re: 2004 Carver 360 Mariner

Post by Viper »

Ya usually under the forward bench of the dinette. I believe I've also seen them under the helm behind the bench in front of the helm. You access that area through the bench. It was a spot for the air conditioner as well in some models.
User avatar
GlenburnieBoater
Scurvy Dog
Scurvy Dog
Posts: 4
Joined: May 1st, 2021, 10:57 pm
Vessel Info: 2004 360 Mariner
Location: Maryland
Has thanked: 3 times

Re: 2004 Carver 360 Mariner

Post by GlenburnieBoater »

It’s not under the dinette (unless we cut through cabinets). Those accessible spaces are empty.

Areas under flybridge are empty.

Going back to the dinette, it’s possible it’s under the floor of the compartments under the seats, but we would have to remove about 20 screws. Does anyone have any input? Again, this is a 2004 Carver 360 mariner
User avatar
bud37
Admiral
Admiral
Posts: 5184
Joined: April 23rd, 2015, 10:22 pm
Has thanked: 604 times
Been thanked: 1312 times

Re: 2004 Carver 360 Mariner

Post by bud37 »

GlenburnieBoater wrote:QR_BBPOST It’s not under the dinette (unless we cut through cabinets). Those accessible spaces are empty.

Areas under flybridge are empty.

Going back to the dinette, it’s possible it’s under the floor of the compartments under the seats, but we would have to remove about 20 screws. Does anyone have any input? Again, this is a 2004 Carver 360 mariner

You shouldn't have to cut thru anything.....on the 350 earlier models it was under the dinette seats when the dinette was on the other side, you had to lift out the storage tubs to reveal the access. The Carver parts shows it below the dinette area on the starboard side for your model, but maybe in a different spot on an earlier version......perhaps check all the seat area, you may have to undo some screws to get a panel off, but really shouldn't be too bad as you have to be able to service it somehow. Good luck man.

There are a few 360 owners on here who may chime in.
FWIW.....The above is just my opinion.
User avatar
Scott892
Scurvy Dog
Scurvy Dog
Posts: 9
Joined: January 26th, 2021, 8:12 pm
Vessel Info: 2007 Mariner 360
Crusader 6.0
Location: Chicago
Been thanked: 2 times

Re: 2004 Carver 360 Mariner

Post by Scott892 »

I have an '07 Mariner. Water Heater is behind bench in bow. Lift the back of the bench off, pull vinyl covering off. My heater heater is directly to the right when looking in the hole (would be port side).
User avatar
GlenburnieBoater
Scurvy Dog
Scurvy Dog
Posts: 4
Joined: May 1st, 2021, 10:57 pm
Vessel Info: 2004 360 Mariner
Location: Maryland
Has thanked: 3 times

Re: 2004 Carver 360 Mariner

Post by GlenburnieBoater »

Found it! Under the forward bench/helm console
User avatar
GlenburnieBoater
Scurvy Dog
Scurvy Dog
Posts: 4
Joined: May 1st, 2021, 10:57 pm
Vessel Info: 2004 360 Mariner
Location: Maryland
Has thanked: 3 times

Re: 2004 Carver 360 Mariner

Post by GlenburnieBoater »

Thank you all!
Viper
CYO Supporter
CYO Supporter
Posts: 6267
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 475 times
Been thanked: 1791 times

Re: 2004 Carver 360 Mariner

Post by Viper »

:down:
Post Reply