Just bought the Carver and may need help/advice. Glad I found this site.

I need to remove the skyscreen in my salon (2016 C37) for repairs, and to do so I need to remove the four ceiling panels that cover the frame as shown in the attached picture. The skyscreen manufacturer says these are held in place with some sort of plastic fastener and "should pop out easily if you pull on them." To me that's a leap of faith. Has anyone ever done this (successfully)? Is it as easy as he made it sound - and just as easy to put back?

Hi to all, my name is Luc and new to this forum.
I have a 2002 carver 444 cockpit motor yacht and looking for a new sender for the fresh water tank.
Who do I call to get the correct model number?

Good day all,

I have a 97' 355AC and yesterday our salon and V berth air conditioner stopped working. What I mean by that is that the water pump and compressor stopped running. The fan on the AC unit will interestingly will run. I know the water pump works because it works for the aft cabin airconditioner. Also when the aft cabin AC unit runs, theres good water flow out of hte boat and the sea strainer is clean.



Does any one have any experience troubleshooting these systems? It's a Marine Air, VRP ...

Hey.

Where is my best bet to find matched gelcoat for a 65 Marquis from 2007?

Just wanted to pass along something I found that may be useful to others.



As you can see from the pics attached, our screw cover/trim molding on the exterior was in pretty poor shape. After much research, I found an Amazon supplier that would send samples of various sizes and colors for just the cost of shipping. So I ordered a set and they turned out to be really nice.



While all three profiles (1/2", 5/8" and 3/4") would fit into the slot, the 5/8" gave us the look we were going after and provid ...

I need to replace the stateroom port hole windows on my 1986 Mariner. Where can I find suitable replacements?

Have a 2016 C37. The screen under the moon roof (is that what it's called?) in the main salon has come loose from its tracks. Any suggestions on how to fix this or get replacement parts? How hard is it to remove the headliner if necessary? Thanks.

Confused here a bit. Just spent 3 hours on a 1986 Riviera considering a purchase. Probably not gonna happen as it needs all new canvas and I suspect that’s quite a few $$$

Here’s my confusion I was reading some posts here by or about Riviera owners etc and they indicated it had a BW v drive? The boat I was looking at had straight BW velvets? Twin merc chevys.

Did this set up vary due to engine? Just interested.

It appears to me that the forward window frames (and possibly the forward parts of the side windows) are made of wood and are deteriorated to the point of needing replacing or rebuilding. Anyone else come upon this phenomenon? Anyone ever replaced the wood framing? I surely could use a few pointers. Is this something a good carpenter can handle as there are no boat builders or fiberglass boat repairers where the boat is.